0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you connect car alarm system to the car horn?
of coures it will connect with a wire
How do you put a car system in your car?
it depends on the what system you are talking about and the car it is going in, you have the car alarm system, remote start system, alarm system, and car stereo system, and every car is different
How do you disconnect car alarm wire from your car battery on a 1996 Honda Accord ex?
how do i disconnect a car alarm wire that runs to the batter form a 1996 Honda accord ex
Factory alarm system quit working?
my alarm system keep disable my car how do I reset or disable this alarm system
How is a viper alarm installed into a vehicle?
One can install a Viper alarm system with minimum electrical knowledge. The system has 12 wires. The red and white wire need to be connected to the trunk release wire. The fuse of the red wire needs to be attached to the 'plus' terminal of car battery. The brown wire needs to go to the siren of the car, the yellow wire to the 'plus' of car ignition, the black needs to be attached to the hood as ground, purple wire with 'minus' of dome light, green wire with 'plus' of dome light, blue wire with the sensor pins and orange wire with the hood.
Chrysler LHS disconnect alarm system so it will start?
You need to ground it out by opening the passenger door locate the green and red from the door to the car it should be the only one in front, take a strait pin and push it into the wire coating until it hits the wire inside next ground the pin to the car body with a solid conducting wire start the car and remove the wire ground and pin. this will disable the alarm but you need to make sure you do not lock the car until you get a remote working for the car or the alarm will go off again. Good Luck
Why does your car alarm keep going off?
When a car alarm goes off, it is a warning that an unwanted person is entering your vehicle, or basically you are accidentally pressing the "activate car alarm" on your portable lock unlock car system. if these are not one of the answers, the main wire that connects the alarm to the outside parts of the car has something wrong with it. since im not all good with cars, you could probably get it checked out at a local car maitanance place.
What is the purpose of using soldring wire in rain alarm?
so that the vibrations in the alarm don't interrupt the electrizity system
What to do when your car jerking?
Pop the lock and hot wire the car so alarm dont go off
Can you put a car alarm on a car with no power locks?
Yes you can put an alarm on a car with no power locks, you can even buy central locking system that you can fit to a car with no power locking system that will connect up to the alarm system. Danny from Bee Mech Mobile Mechanics Find me at www.beemech.com.au
How do I connect my car alarm system to my car horn?
In an alarm condition, the siren output is a steady output, rather than a pulsed one. To connect the car alarm system to the car horn, simply hook it up with the relay to switch the horn power.
Where can one purchase a new car alarm system?
One can purchase a car alarm at a store that sells car accessories. The dealership where one purchased the car might also be a good source for a car alarm.
