Want this question answered?
The old capacitor was very swollen and looked like a soda can that had been repeatedly shaken up. Be sure to write down which wires go to what terminal on your capacitor before removing the old one or just take a few pictures. For home air conditioning systems that use dual run capacitors they will have 3 terminals. The terminal labeled "HERM" is for the yellow wire that goes to the "Hermetically Sealed" compressor. The "FAN" terminal gets connected to the brown wire that goes to the condenser fan. Finally the "COM" terminal is for the purple and red wires that go to the contactor and provide power to the capacitor.
No.
capacitor stores charge ,so we use capacitor in fan for continuous voltage supply.
The Capacitor with running winding is connected in parallel with main winding.
It could be off on a low pressure switch. You need to check if you have 24 volts to the outdoor unit at the contactor coil. If the contactor is not working the outdoor unit will get no high voltage to the compressor or fan. It could also be that the capacitor for the fan and compressor is blown.
Yes it can. If the fan is not coming on you could have a bad fan motor, a bad capacitor, a loose wire at the contactor, or a loose wire at the capacitor.
Do you have a dual capacitor that starts both the compressor and the fan motor? You need 230V to power the compressor. You should have one wire from the capacitor going from the start terminal on the compressor and one going from the common terminal to common on the capacitor.
The old capacitor was very swollen and looked like a soda can that had been repeatedly shaken up. Be sure to write down which wires go to what terminal on your capacitor before removing the old one or just take a few pictures. For home air conditioning systems that use dual run capacitors they will have 3 terminals. The terminal labeled "HERM" is for the yellow wire that goes to the "Hermetically Sealed" compressor. The "FAN" terminal gets connected to the brown wire that goes to the condenser fan. Finally the "COM" terminal is for the purple and red wires that go to the contactor and provide power to the capacitor.
Check your outside unit. Is the fan blowing? If not replace outdoor fan motor or the fan capacitor. If the fan is running then the compressor may not be. Usually a quick fix by replacing the capacitor. In most units a dual capacitor that is bad may shut down the fan or compressor. Call a HVAC technician to replace it. This can be very dangerous.
Common wire of the potential relay goes to the compressor contactor. (5) Start wire of the potential relay goes to compressor run capacitor. (2) Run wire of the potential relay goes to the start capacitor. (1)
Yes, but usually one side of the capacitor will completely go out. Either the fan or compressor will not work. First look at the capacitor. Usually they swell and the cylinder shape becomes rounded on the bottom or top. If you know how to work a meter, disconnect the leads on the capacitor and check for continuity (ohms). Put one lead on the Common and the other or Herm then move it to fan. Look for a rise and fall in ohms. If its bad, continuity will be lost on either side. Depends on what you are trying to repair, fan or compressor.
Bad fan motor or bad capacitor.
bad motor or capacitor
Check the capacitor located inside the outside condensing unit,usually the fan,compressor are wired together,if one is running the other should be running
It should say on the compressor and the fan motor labels.
Check to see if the capacitor is good. It is usually located inside the outdoor unit. It could be that the capacitor is bad and needs replacing. The outdoor fan will still run if you have a dual capacitor. One sure sign of a blown capacitor is that the top of the capacitor is bowed outward. If you have a multimeter you could also check the amp draw on the condensing unit. I would look at the capacitor first though
the capacitor starts the compressor generally if it don t work the compressor usually won t start