In North America adouble pole single throw switch is usually used to disconnect a 240 voltload by disconnecting both hot supply wires. This is a safety procedure to prevent someone getting a shock when working on the load and thinking the supply is off just by opening the switch. Although just opening up one leg will turn the load off the remaining leg will still be "hot" to neutral and ground. The "hot" wires go to the top of the switch terminals and the load connects to the bottom two terminals on the switch.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
with a standard 1 pole light switch (one switch operating the light) it is black wire to black wire and white to white (non grounded)
the safest position for a switch is on the live wire and not on the neutral wire
See discuss question below.
This is what the purpose of a switch is. It connects the "hot" wire to the load. When this is done the load becomes energized.
If it is a 2-wire switch- yes If it is a 3-wire switch- no
Wire the switch to the hot/black lead.
You have a 3 way switch. Your black wire is the hot wire. Your green wire is the ground wire. Your red and white wires go to the light and other switch. You should have gotten a wiring diagram with your switch.
A switch is inserted in series with a single wire. When the switch is on, it is as if the wire had not been opened to insert the switch. When the switch is off the wire is open and no current can flow. All a double pole switch does is allows you to switch two separate wires at the same time with the same switch action. A single pole switch just switches one wire.
with a standard 1 pole light switch (one switch operating the light) it is black wire to black wire and white to white (non grounded)
If you have one wire into your switch box for your light. this is called a switch leg, the dimmer should be wired across the black and white wire wires.
When the neutral wire goes to the switch
Current flows through a wire when a light switch is turned on.
the safest position for a switch is on the live wire and not on the neutral wire
I need a wiring diagram to wire a furnas boat lift 6 wire switch Milt milt_jan@yahoo.com
See discuss question below.
This is what the purpose of a switch is. It connects the "hot" wire to the load. When this is done the load becomes energized.