answersLogoWhite

0


Best Answer

How many peak amps does it use.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you wire a inverter to my truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What do you need for your truck if needing to plug your labtop in a converter or inverter?

What do u need for a dodge truck if u are needing to run a tool that is 120volts a inverter or converter


What do you use the inverter for on roblox?

The Inverter is a sort of Backwards device.Let's say if you wire up a button to an Inverter and the Inverter is wired up to a Wiring door. When the Button is turned off, the door will open. When the button is turned on, the door will close.


What wire should you use for your 2500 watt inverter?

To answer this question have to know the voltage you are using.


What color is the hotwire in a Mazda b2300 truck trying to wire a radio?

What is color for hot wire on a 1996 mazda b2300 truck for radio


When using truck battery with inverter can vehicle still remain running?

Most inverters will not be harmed by charging the battery [running the engine while the inverter is connected]. However, for safety [inverters are expensive] it is best that the Owner/User Manual be consulted to make sure that it is safe to charge the battery while the inverter is connected.


Do higher watt inverters drain batteries more than lower watt?

The inverter draws little current on its own. It is the load that is connected to the inverter. If there were no load on the inverter you could use an ampmeter to determine the no load current. One thing to consider is that a higher wattage inverter would have larger gauge wire which is of lower resistance. This could make the no load current lower for the higher wattage inverter. Bottom line is you would have to measure or have a specification on the no load current.


What inverter did a 1990 van buckit truck come with?

The inverter was an aftermarket accessory, as was the entire bucket body. The manufacturer had a range of options they could choose from as far as accessories such as an inverter went. There should be an ID number on the bucket lift somewhere. If the manufacturer is still in business, they might be able to pull up the production record and tell you this.


How do you wire a coil on a 1976 ford truck?

positive wire is the live wire it goes to the + term ground goes to - term


What is the size of a refrigerator in a semi truck?

Most will accommodate a 15 x 15 x 21 " unit. If no inverter, of course 12 volt. If u have an APU with a good sized inverter, u can get a compressor type unit instead of the thermoelectric variety


How do you wire a 3000 watt inverter into a 200 amp disconnect panel?

You're asking about something that is potentially very dangerous. There is some very specific equipment that isolates an inverter from the utility main. In the event of a power failure, if your equipment is installed improperly you could cause injury to utility workers. Do NOT install the inverter if you are not properly trained and have an adequate knowledge of not just electricity, but also extensive knowledge of the inverter and disconnect equipment.


Which wire is power and which wire is for memory for a for the radio on a 1990 Nissan pickup truck?

Go to www.installdr.com .


How do you wire a 240 volt well pump to an inverter?

The first thing you want to do is make sure that you have a large enough inverter for the voltage you are trying to accomplish. Do plenty of research and make sure that you know exactly what you are doing the results could be terrible. When all else fails find a local trusted electrician and have them come and hook up your inverter for you.