I think you can by attaching it to you spark plug wire
a tachometer, wire and wire terminals
White wire coming from the distributor.... remove a section of sleeve from wire and splice the signal wire from tachometer to it!
i dont know whwere is the tachometer wire of 2001 ford windstar
Green wire on the distributor is the tachometer pick up. Green wire on the distributor is the tachometer pick up.
YELLOW
A wire brush, emery cloth and solvent. Then check the gap.
Use an inductive pickup on plug-wire #1, and connected to tachometer located in vehicle.
this depends on the year, that will determine the type of ignition and the conection.
The tachometer on a 1991 Acura Integra is wired through the dash. To reach the wiring remove the dash console and pull out the tachometer. There the wiring can be worked on using a spark tester to find the bad wire and solder unit to replace the wire.
white
On the 88 jeep the trigger wire at the tach is blue.
the green is the signal wire and it goes to the negative side of the ignition coil