0
What work needs done? You will need a good set of metric tools, and the rest depends on what is wrong with the engine.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
1994 Ford Probe squeals when started?
I Have 94 Probe 4 cylinder that squealed when I started it. the pully on the water pump was lose
How do you bled the slave cylinder for a 94 Ford Probe gt?
take it to the shop u nee a special tool to do it
Will a 1994 Ford Probe Alternator fit on a 1993 Ford Probe gt?
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
What refrigerant does 94 Ford Probe use?
r134a
Can a 1989 Ford Probe tranny fit 1993 Ford Probe tranny?
noAnswerno the only years that will work are 93 to 94 ford probe, 93 to 94 Mazda 626, and 93 to 94 Mazda M6 and if its a (CD4E) Transmission good luck you will need it! Answerthe tranny form a 93-95 should work i swaped my auto out to a 5 speed from a 95 and my car is a 93 works fine few extra parts left over
94 Ford Probe 4 cylinder stalls at idle Replaced MAF sensor fuel pump fuel filter fuel pump relay Why is it still stalling?
Because it's a Ford.
Can you make a 94 probe auto trans wire harness work on a 93 ford probe trans without cutting it?
yes should work fine might be some diff in plugs that you might have to rewire but should have no proble there are few diff between the 93-94
Will a 93 Ford Probe door fit a 95 Ford Probe?
Nope 98-94 is one model. 95 starts a new design.
Why would a 1993 Ford Probe 4 cylinder cut off and stall when car is driven for 10 minutes?
hi! i had the same problem on my '94 SE and it was caused by the distributor.
Will the engine and transmission of a 1995 Ford Probe fit into a 1993 Ford Probe?
Yes,but the 93 and 94 enginges are obd1,while the 95-97 are obd2.
Where is the trans filter on a 94 Ford Probe?
inside the trans. not a job for amatuer
Is a 94 Ford Probe interchangeable with a 97 Ford Probe?
Yes. body parts, interior parts and most motor componets are interchangeable. However, the 94 Probe is an OBD-I and the 97 Probe is an OBD-II so there are additional sensors on the 97 Probe to consider if swapping motors/wire harnesses, etc.
