it works two ways
2 sticks go in 1 hole.
because your tail light works off of other side of a 2 way bulb.change bulb and will fix problem
To wire a 3-way switch with 12 2-wire to control a light fixture from two different locations, you will need to connect the wires in a specific way. The 12 2-wire should be used to connect the switches and the light fixture. Follow a wiring diagram for 3-way switches to properly connect the wires and ensure the switches work correctly to control the light from two different locations.
It is doubtful that the hall light is the starting point of the power. You could add a closet light that would work when the hall light was on, but probably not to work independently.
A LDR or light dependant resistor is a resistor that works when light is not shining on it, so if there is light on it it will not resist a current, you can also get them to work the other way.
by your
The best way to make a fire with 2 sticks is to light them with a match.
3-way switches work by allowing you to control a light from two different locations. They use two switches connected to the same light fixture, with one switch turning the light on and the other turning it off. The switches are wired in a way that allows them to communicate with each other to control the flow of electricity to the light.
yes it worked the exact same way it does now.
It doesn't work that way. The light-year is not used to measure the speed of light. It works the other way round: First, the speed of light is determined through other methods, then the distance called a light-year is calculated based on that measurements.
b/c your brak light is blown..and all the rest will work but that one.that or you have a fusa that is not working one of the 2
light has properties of both a wave and a particle whereas sound travels exclusively as a waves. i think Einstein did some work with light waves