13B for N/A and 13BT for Turbo models.
Motorcycles, propeller aircraft, automobiles, chainsaws, etc. Anywhere a light high output engine is required.
rotary engine on a propeller powered plane
Rotary means going around, like in a Wankel. Reciprocating means going back and forth. like in a ordinary piston engine.
Encoders are sensors that generate digital signals in response to movement. Both shaft encoders, which respond to rotation, and linear encoders, which respond to motion in a line.
it the engine code. 2 rotor, naturally aspirated rotary
Mazda's 13B for the 1986-88 RX-7 made 146hp without a turbo and 185hp with a turbo.
Do an internet on a Mazda RX7 or RX8... other than that ....it's basically an airplane engine..... --------------------------------------------------------------------------------------------------------------- A rotary engine, or formly known as the "wankel" engine was created/invented by Felix Wankel back in the 1920s i believe, prototype was designed an released in 1959. Mazda well know for the RX(Rotary Experiment) Gen cars 1-8. There are a few kinds of rotary engines, the ones in airplanes, and the ones used in cars/trucks. The basic rotary engine from a car IE Rx7. has a 13b rotary engine, which is a 2 rotor model. The rotary engine , instead of a traditional piston engine does not go up an down, instead goes in circular motion (which allows it to get way more RPMs). there are plenty of rotary engines 12a,13b,20b, and 26b(which is hard to come close too...AND ALOT OF $$$$$) thats basically a lil about the rotary engine!!!
Its hidden under the camshaft
check out rotary engine illustrated - there is a video you can download that shows how the timing works. if you search it on google then you will find it.
On a 1986-91 model they connect to the throttle body and the turbo compressor ! Hope it helps!
If you are speaking of the 13B N/A, the pistons that actuate the 6th port sleeves operate via vacuum from the "Pick up Tube" on the catalytic converter on the Exhaust piping. Either you have a rotary engine or a piston engine.
140 nm
Yes, the engine block of the 13B rotary engine wieghs about 85-100lbs. its very small, most likely smaller than the 4cyl in the Protege. i know because i own 3 rx7's. hope this helps.
pretty good explanation here...http://auto.howstuffworks.com/rotary-engine.htm
any engine will fit just about in any car. you will need new motor mounts, tranny, rear end, driveshaft, wire harness, and speedometer cable.
Since RX-7's have a completely different engine, 1.3 liters may sound small but it's not. Most compare the power displaced by a 13b rotary to that of a 6 cylinder piston engine.