See discuss question below.
No. A circuit breaker is like a fuse, it protects a circuit from a catastrophe if a dead short should occur.
If you feel love for a certain person, it is hard to let go of them no matter what they do to you.
If a breaker in the breaker box isn't working, first ensure that the breaker is fully in the "on" position. If it trips again immediately or doesn't stay on, turn it off and check for any overloaded circuits or damaged wiring connected to that breaker. If the issue persists, consider replacing the breaker or consulting a licensed electrician for a thorough inspection and repair to ensure safety. Always prioritize safety and avoid working on electrical systems unless you are qualified to do so.
A breaker trips because the circuit load has tried to draw more current that the circuit is designed to operate at. You have to establish what the total current draw of the device is. This can be found on the manufactures label. There it will state what the normal amperage draw is for the specific piece of equipment. If the breaker has tripped, look for the cause and rectify the problem before resetting the breaker. If you found the problem and corrected the cause, the breaker will reset and stay in the on position.
It's in the basement. Turn on the light switch behind the dryer, walk past the furnace, stay to the left of the water heater, and you'll eventually see the breaker box on the wall in front of you. For heaven's sake, do be careful.
the stone breaker
The only way your electronics will work if you turn off the circuit breaker to the surge strip is if they are able to run on battery power. If the surge strip is connected to a UPS (uninterrupted power supply) as many commercial offices are, the electronics will stay operable until the circuit breaker is reset or turned back on if purposely turned off. If the utility service is off, the electronics will stay operable until the power is restored or the UPS power source fails.
what is a rocker breaker
deal-breaker circuit breaker jawbreaker heartbreaker
The voltage before the breaker is from the distribution panel's buss bars. This voltage is controlled by the panel's main breaker. To have no voltage on the terminal of the breaker means that either the breaker is shut off or it has gone into a trip position. If it has tripped push the handle of the breaker to the off position and then to the on position. This should reset the breaker. If the voltage is not present at the output terminal of the breaker after resetting it, then replace the breaker as it has a fault in it.
Does anyone know what brand breaker replaces a Gould breaker???
You will need a multimeter to check a 220 volt breaker. You should unplug appliances that go to that particular breaker. Use the multimeter at the breaker to check the voltage. If it shows 220, then the breaker is okay. If it doesn't, then the breaker is no good.