Want this question answered?
We usually indicate that the output is dependent on current state and input by drawing the output on the edge.
ok
Independent SourcesIndependent sources produce current/voltage at a particular rate that is dependent only on time. These sources may output a constant current/voltage, or they may output current/voltage that varies with time.Dependent SourcesDependent sources are current or voltage sources whose output value is based on time or another value from the circuit. A dependent source may be based on the voltage over a resistor for example, or even the current flowing through a given wire. The following sources are possible:Current-controlled current sourceCurrent-controlled voltage sourceVoltage-controlled current sourceVoltage-controlled voltage sourceDependent sources are useful for modelling transistors or vacuum tubes.
A: It is a transformer that has one or more leads wire output so switch can be used to change the output voltage from a reference wire.
Force affects the speed of power output. If the driving force is slow, the speed of power output will also be sluggish. Alternatively, if the driving force is fast, power output will be able to match the speed.
The bulb has resistance which then gets smal
as it is rate of change of output voltage..so it affect amplifier output
The change in the input value is equalto the change in the output value.
No, the output will remain constant. If you double all the values, the divider ratio will not change, and it is the ratio that determines the output voltage. The current flow through the divider itself will change, it will be half the original value. This could affect the accuracy of the divider. For the same accuracy, the minimum load resistance would be double the original value.
The input is a Gate that is essentially infinite impedance, so no current. The output is essentially the resistance between Source and Drain, which controls the current flowing through it.
Leverage Ratio is an idea of how a change in a company's output will affect their operating income. It is used to measure a company's mix of operating costs, showing how a change in the company's ideas will affect the output of their operating income.
It is a language in electronics describing whether the output is a pulse or direct current for any output.
Why input current of USis less than Output current?
The change in total output, when one more input is added/deducted. If Total Product of current period 'n', then the Marginal Product [Marginal Output]= Tn - Tn-1. It is the marginal change in the total output when one unit of input say labour or capital is added.
With increasing torque load the armature tends to slow down; the motor draws more current to compensate, and if there is armature resistance the back emf generated by the armature falls to allow the increased current to flow, which causes the motor to settle at a lower speed. The mechanical output power is the speed times the torque, and increasing the torque increases the power output provided the speed does not drop much.
An electromagnet isn't designed to output any temperature. If it does that, then you can be sure that the size of wire from which it's wound is too small to safely carry the current it is carrying.
The output short circuit current is the solar cell's current when the voltage is zero, or when it, is short circuited.