It doesn't.
(Please note - the folllowing explanation is for wood latt NOT lathe) A piece of wood, fairly flexible, usually about two inches wide and about a 1/4 to 1/2 inch thick and as long as necessary. It is used for lattice work and is often found as a base for plaster walls in older homes.Wooden table legs are turned ona wood lathe - the wood lathe is used to make a square pole of wood round.How a wood lathe worksWood Lathe Basically, a small engine, usually electric, turns a set of gears. These gears are connected to more gears via a V belt (a loop of rubber, tightly on the two gears).The turning of the gears turns the lathe.Depending on what you are lathing, the actual setup of the cutting instruments varies. The best way to find out how to use a lathe is to go and take a course at TAFE.A lathe , as you most likely know, is a machine that spins a peice of wood at a high (or low ,depending on what you are carving) velocity. It consists a motor, tool rest, and peices of metal to hold the wood in place. The peices of metal used to lock the wood into place vary, depending on how it needs to be held. You use a chisle, (once again, different variaties of chisles) to carve the wood while it is spinning.
It guides your drill so that it doesn't drill off center. Drilling into a flat surface with a standard drill is not going to work or in the rare occasion it does will atleast give u a headache trying.
Milling in a lathe can be two things:A cutter is gripped in the chuck and a workpiece the the tool post. The work piece is then milled by using the feed on the lathe. Although it has been done, it is an unconventional method and is not recommended.A 3-in-1 lathe with a milling attachment as part of the machine used for milling a work piece.
People that work on a metal lathe are called a Turner, a Machinist or a Lathe operator depending on their trade or qualifications.
Richard Raffan has written: 'Taunton's Complete Illustrated Guide to Turning (Complete Illustrated Guide)' -- subject(s): Lathes, Turning, Turning (Lathe work) 'Turning wood' 'Turning Bowls with Richard Raffan' -- subject(s): Bowls (Tableware), Turning, Turning (Lathe work) 'Richard Raffan's Turning Guide' 'Turning wood with Richard Raffan' -- subject(s): Turning, Lathes
While John lays next to the pool, his brother is at work machining shafts on a lathe.
Lacquer-work is a highly skilled decorative art in which the artist shapes the wood using a hand operated lathe. Then several colors of lac are applied, design is then incised with sharp tools exposing the colors of the underlying layers.
it is basically used for machining..
Finder works just like the Start button on a Windows PC.
David Fenner has written: 'Mini-lathe for home machinists' -- subject(s): Turning (Lathe work), Lathes
yes,