in the carburetor float bowl, set at 21mm when sitting at closed position. measure from top lip edge of body to top of float. dont forget the needle and seat need to be clean
Yes, but expect tuning issues. Change the cams as well. ignition timing? all have to be considered. not a bolt on solution. Go to Randal Randakk's GL1000 site he is the expert on carburetors for all GL1000 http://www.randakks.com/
If you were to go there you would either float...or not float. You choose;)
Only if you make it from materials that float, but then it wouldn't be a go cart, but a float cart. It wouldn't be heavy enough to stay on the road as a go cart.
Go down to type. Then select float.
No they do not float they sink right to the bottom so if I was you I wouldn't use them to go swimming with.
If you press shift and then click were you want to go u can float
What you can do is on most of the pocket bike carburetors there is a little screw that you can a dust that will increase the speed
asteoids do not float because they hace craters so they catch air and go fast
First, Honda did not mak a "750" Goldwing. In 1976 the Goldwing was a 1000 cc machine known as the GL1000. As for transmission fluid, the 1976 GL1000 does not use transmission fluid. It has a wet clutch, and the engine oil provides all the lubrication that the clutch and transmission requires. For this reason it is extremely important to use the correct engine oil and change it at regular intervals. For detailed information check out www.randakks.com.
The Go-Go's was created in 1978.
Go into deep water and you can swim.
Their is no float but there is guppy the whale! go to the map and click the picture of a whale! click travel here then you will go there right away!