Want this question answered?
order new belts from an OEM supplier with new bolts and washers. remove rear seat and go to work!
Rear seat cable latch system broken and does not work. Seat does not pull forward to allow access to the 3rd row.
on back of the seat bottom cushion there are finger tabs, you must pull straight up or they will not work.
loose or broken wires between door jamb and switch
i need to know the year, model, motor size.chuck
Each of the four doors has a vacuum element that locks/unlocks each lock. The vacuum pump also called a pse pump is located under rear seat next to the battery. This pump supplies the vacuum to each of the door locks when activated.
i have the same problem i think it has to do with the fuse box in rear seat. the whole driver door doesnt work . only the light and speaker, but i can do anythin except in passenger . i exchanged the modules ,now im goin to check the fuses in the back seat i have the same problem i think it has to do with the fuse box in rear seat. the whole driver door doesnt work . only the light and speaker, but i can do anythin except in passenger . i exchanged the modules ,now im goin to check the fuses in the back seat
i know kpm can't, try motor aid in hainault, they repair the rear steer , and give you 1year warrantly there work, hope this help .
According to my owners manuel, there is a hidden button on the back of the seat in the middle (in the middle on the right side on the driver's seat and in the middle on the left on the passenger's seat) and you push that and it should come out. And I think the headrest may have to be all the way down for that to work. Hope this helps.
I can assume that you are talkin about centre belt cause they seem to be a big problem. First of all before you go there , there is a cable that runs from the seat belt unit to the catch that your seat clips into when you have laid it down. You will probably find that the seat catch is not engaged properly which stops a cable from retracting and allowing the seat belt mechanism to release. Try lubricating the latch at the rear of the seat and also slamming. This is a safety device so if your seat is not clipped in properly you cannot pull out seat belt. If this doesn't work - Unclip the the rear protector on the rear of your seat and you will see along the edge of the seat near the bottom ,where you undo the fabric from the seat . Fold the fabric at the top away after unclipping the plastic insert were the belt goes into the seat, You will see some screws holding a steel plate over the belt. Remove the plate - Look on the back of the seat on the steel part and there is a bolt holding seat belt in place , Undo this and abstract seat belt from between foam and release cable from seat belt..
I have same problem on my truck seems that you have to replace the d.s.m. driver side module under the seat, because that controls all electric power to seat, pedals, and rear view mirrors.
It will with modifications to the front slip mount. To modify the front slip mount: Slot your 650 rear metal bracket with a drill bit to fit the hole pattern on the 1100 seat. then you'll need a u bolt that is the correct width to fit the holes on the frame slip mount since the seat will not bolt down in the rear with it slipped into the stock front mount. A little work and the bigger more comfy seat will fit and look good.