Oldsmobile Cutlass 442
Oldsmobile Cutlass Supreme

How does the carburetor on a 1999 Oldsmobile cutlass work?


Top Answer
User Avatar
Wiki User
2013-02-03 21:06:02
2013-02-03 21:06:02

Just like the radiator on the 1966 VW Beetle.... because neither exits. The last American carbureted auto engine was a 1990 Oldsmobile.

User Avatar

Related Questions

A 1999 Ford is fuel injected, it does not have a carburetor.

To reset the computer on a 1992 Oldsmobile Cutlass Supreme, unhook the battery for about five minutes. Then reconnect the battery. If this does not work, look for the reset button on the computer and manually reset it.

No. Everything about the two cars is completely different.

Most likely either a bad float in the fuel tank or defective gauge

It's less than 2 hours work - depends on local labour cost.

Loose or missing belt - Lack of fluid - broken pump

Yes, Chevrolet, Pontiac, 3.1 Liters will work as they are the same engine.

first poo your pants and eat it hahahaha take that society

Having water in the gas tank will work its way up to the carburetor.

Beneath The Air Filter, Or Duct Work From The Air Filter. If You Have A V6 In The Center On Top Of The Engine. Its Looks Kinda Like A Carburator. Good Luck

a 1982 cutlass and a caprice do. the Cutlass likely has 14 inch rims and the Caprice 15's but they work

A carburetor is found in an internal combustion engine. The purpose of the carburetor is to blend fuel and air.

I would start by checking the fuse, the relay, and the connector on the blower itself.

If you can't make it to work with your fader and balance adjustment buttons, then it is broken and should be replaced.

A transmission fluid leak means that the plug may need to be replace, or the seal or gasket may need to be replace. As it could be caused by a work seal, or gasket, or a loose plug.

The frame from ANY GM A-body of the same body type (2-door, 4-door, etc) will bolt right in because they all use the same frames. So a frame from a Chevelle, Tempest/Lemans/GTO, Buick Skylark, or Cutlass will fit. Any frame from 1964-1967 will work. 1968 and later frames won't work because the wheelbase changed in 1968.

v-6 located between the center firewall and on the top rear of engine. has one wire connector on it. In the exhaust header between the engine and the radiator. Couldn't be easier to find and work on.

Yes they can. They are pretty much a direct swap. I have heard a rumor that on a olds cutlass supreme, there is one bolt that is different in between the 2 years. But other wise, if the car is the same model, it will work.

A carburetor is a part of a combustible engine that blends the air and fuel so there can be ignition. It is one part of the engine that you cannot do without.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.