To reset the computer on a 1992 Oldsmobile Cutlass Supreme, unhook the battery for about five minutes. Then reconnect the battery. If this does not work, look for the reset button on the computer and manually reset it.
can i reset it or replace it ,where is it on the car
You don't really need to reset the computer. It does have base programming. However, it is recommended to take the car out and drive it about 10 miles. Some of this needs to be at highway speed. This will help it to "learn" the exact settings it needs. That should do it.
Sometimes it is best to reset the computer of a car to help maintain it. To reset a computer a person needs to take their car to a dealership, and ask for the task to be done.
GM cars do not use inertia/reset switches.
There is a fuel cut-off switch under the hood that needs to be reset. Should be on the left side near the back.
To reset the security system on a 1997 Oldsmobile Cutlass Supreme, first ensure the vehicle is in the "Off" position. Next, turn the ignition key to the "On" position without starting the engine, and leave it there for about 10 minutes. After this period, turn the key back to the "Off" position, wait a few seconds, and then start the vehicle. If the problem persists, you may need to consult the owner's manual or a professional mechanic for further assistance.
1-Cold weather - normal operation. 2-Computer reset, especially after battery replacement. 3-Low coolant (antifreeze) level. 4-Stuck IAC. 5-Air conditioner turned on. Defroster included.
I have a 1993 olds cutlass supreme and I removed the fuse for the ecm. Its located in the main fuse box in the glove box. I know 1994 was the 1st year for the airbag so Im not sure if it uses the same dash layout as the 93. And as an added measure I also removed the positive battery cable and let the vehicle sit for 10 minutes I believe that you can also reset the whole car by pressing the gas pedal all the way to the floor and letting it out 3 consecutive times. It will reset the WHOLE car.
GM vehicles do not use inertia/reset switches.
i have 1991cutlass supreme v6 my digtial gas gage stuck
GM vehicles do not use inertia/reset switches.
Disconnect the negative terminal on the battery for 30 seconds. The PCM will reset.