Disconnect the negative terminal on the battery for 30 seconds. The PCM will reset.
On my aurora, I just hold in the reset button.............
Does not have one.
How do you reset antitheft in oldmobie auroa
To reset the computer on a 2001 Oldsmobile Aurora, you must press and hold the on/off button for a few seconds. This will switch the computer from English to Metric mode or which ever way you choose. This information can also be found in the owner's manual on the first section of the DIC programming section. Hope this information helps someone out there. Aurora owner, Dennis
hold the engine reset button in until it resets
You'll need to find a shop with a code reader that reads ABS computer codes.
To reset the computer on a 1992 Oldsmobile Cutlass Supreme, unhook the battery for about five minutes. Then reconnect the battery. If this does not work, look for the reset button on the computer and manually reset it.
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.
To reset the computer in a 1996 Oldsmobile Delta 88, disconnect the negative terminal of the battery and leave it disconnected for about 15 minutes. This will allow the vehicle's computer to clear any stored codes and reset itself. After the time has passed, reconnect the negative terminal and start the engine. You may need to drive the vehicle for a short distance to allow the computer to recalibrate.
can i reset it or replace it ,where is it on the car
To reset the computer on a 2001 Oldsmobile Alero, disconnect the negative battery cable and leave it off for about 15 minutes. This will clear any stored codes and reset the engine control module. After 15 minutes, reconnect the negative cable and start the vehicle, allowing it to idle for a few minutes to recalibrate. Always ensure you have any necessary radio or security codes before disconnecting the battery.