Want this question answered?
Buy a new cable from the lever to the linkage under the truck near the rear. Remove the old cable and feed the new in through the fire wall. Remove the lever and reinsert the swaged end in the lever.
there is no clutch cable. it has a hydraulic clutch. there will be a clutch master cylinder on the firewall near the brake M/C. a hydraulic hose will connect that to the clutch slave cylinder on or near the tranny. the slave cylinder pushes on a fork (lever) that disengages the clutch.
Follow the positive battery cable down to the engine. It will connect to the starter.
# Remove the cover from under the facia panel # Release the nuts at the end of the cable at the release lever and disconnect the cable from the lever # Working from the inside of the car remove the clevis pin and disconnect the cable from the clutch pedal arm # Unscrew the two nuts which retain the cable grommet to the bulkhead and withdraw the cable from the car
Postive battery cable should connect to the starter relay (solenoid)
disconnect the negative battery cable for 60 seconds then re-connect should do it
I have the same car and this happens to me if you take your right hand and pull the lever and bang the hood with your left near the windshield the top of the hood it might pop loose if you think your cable is broken then the lever you pull on look behind it and find the cable and pull it with a pair of plyers.
Answer Red cable (+) goes to starter solenoid and Positive side of battery Black (-) cable goes to engine ground. When disconnecting a battery always disconnect the ground cable from the battery first. When connecting a battery always connect the ground cable to the battery last.
To change the speedometer cable on a 1990 Toyota truck, disconnect the cable, feeding it through the grommet, then disconnect it from the transmission. The process can then be reversed with the new cable.
cable clutch
Cable - British band - was created in 1990.
The following comments consider the clamping procedure only. There are general safety procedures for this activity to be aware regardless of car type. 1990 Porsche manual page 103 shows emergency starting with jumper cables. Diagram shows first; connect positive cable clamp to positive post discharged bat. , second; positive cable clamp to booster bat. positive post ., third, connect negative cable clamp to negative post booster bat., lastly; connect negative cable clamp to bare metal on car with discharged battery. Read instructions on your cables.