Its very easy, go to your local GM parts counter and order a pigtail for the blower motor resistor harness, all you need to do is cut and connect the appropriate wires together and youll be all set.
You will need to remove the dash and it should be somewhere under
The heater resistor is quite simple to change. Unplug the wiring harness from the heater resistor. Remove the heater resistor retaining screws. Reverse the process to install your new heater resistor.
Drop the glovebox door and you will have access to it.
i need to replace the temperature control light bulb on my 2004 silverado.
Bad blower resistor?
Defective blower motor Resistor Pack. Replace it.
how to replace heater fan resistor on Nissan Sentra 2003
Just did that on mine. You can get the resistor at Autozone, but more than likely, your harness is fried. This is a common problem, but the harness is a dealer only item. The fix is easy, you'll need to take the cover off (big black plastic box under the dash). Just take the screws out & lower the box. You will need to cut the wires & splice the new harness in. Your harness will come with everything needed (connectors). The resistor cost around 20-25 bucks, but the harness will set you back about 100.
Replace heater motor resistor.
How do you replace the fan motor on a jeep cheerkie
in the passenger foot compartment, the duct work for your heater is above the passengers feet, under the dash. there is a harness plugged into a resistor (fan speed) that is held in the plastic duct by 2 screws. unplug the resistor, unscrew the 2 screws, your old resistor will come right out. put the new resistor up in its place, put the screws back in, the plug the harness back in. takes about 20 minutes.
the heater blower resistor is located on the passenger side footwell near the firewall. a complete how-to replace the resistor, along with photos is available on newcougar.org http://www.newcougar.org/forums/how-tos/3732-fixing-heater-blower-resistor-install-photos.html
RIGHT HAND SIDE BEANEATH THE DASH THERE IS A BLACK COVER,TAKE THIS COVER OFF AND THE HARNESS PLUGS INTO THE RESISTOR.
The a/c heater blower motor resister is located in the vehicle on the passengers side inside the housing next to the blower motor...............Remove the blower motor resistor wire harness connector.Remove the blower motor resistor screws.Remove the blower motor resistor.
the resistor is gonna be right off the blower motor attached to the blower motor by a wire harness should be by the heater core
ennngine heater is located at rear end of engine oil cooler on side of engine underneath the mainifold follow your engine oil heater plug in wires back to it and ; disconnect wire harness from heater. using correct wrench unscrew heater from oil cooler. install new heater, reattach wire harness PS . before you buy heater, check that harness is not bad heater and harness do not come togehter when u purchase but heater is about 46 bucks, harness is 78 bucks
It is the resistor, replace it.
You have to replace the fan resistor pack. Open the glove compartment and lower the door, look in back on the firewall. Remove the two screws and the connector, pull out the resistor pack - replace it.
you have waisted my time, thank you
have you checked the fuse if so then you will need to replace the resistor for the blower hig and low dettings have you checked the fuse do you have 12 volts to blower if so then you will need to replace the resistor for the blower replace the blower motor
You can install a resistor in a 2009 Kia Sedona, first locate the heater box under your dash, remove the two screws, and replace with a new resistor.
It should be located on the evaporator case.
How do you replace the heater blower motor resistor on a 1998 gmc serria 1500 p/u
If yourtalking about the heater blower, I believe they are hidden behind the glove box inner liner.
where to find heater resistor 2004