For a rifle that fires between 800 & 1000 FPS you should set your target at 60 feet. You will have to adjust for rifles that shoot at a slower FPS.
Only if the airgun has a scope rail designed into the gun. You will also need an airgun scope not a firearms scope.
A center point scope would probably be better for an airgun considering it would be the most cost effective. A leapers or red dot scope is nice for combat and tactical operations because the illuminated dot allows for quick sighting in high adrenaline situations. I am assuming you are target shooting or hunting small animals with the airgun which is why a center point scope would be a good choice because it tends to be slightly more accurate for a much cheaper price.
It's worth between $10 to $15 used.
im pretty sure you sight it in like every other scope as long as you keep the parellax in mind. sight in at 75 yards
One can purchase rifle scope mounts from websites like Optics Planet, Cabelas, Amazon, Scope Mounts, Airgun Depot, eBay, Talley Manufacturing and Jmecks Scope Mounts.
Both Weaver and 11mm Scope rails are used on air guns and air rifles. So you will just have to try.
you can, but it depends on the airgun. Most spring airguns but two-directional shock on rifle scopes and can wreck them. You can usually get airgun scopes for pretty cheap though. Mostly though, it depends on the gun and the scope.
A collimator is used to "bore sight" a scope. It will help ensure that the scope is close to being properly aligned.
For an actual scope, and not a reflex sight, I tend to favour Nikon, personally, and it's what I recommend to my customers.
The gun is not really designed to hold a scope. The barrel has no way of holding a scope rail. You would have to drill holes in the barrel to mount one. a pistol scope would also be required and it would out cost the price of the gun many times over. a regular rifle scope would not work. So I suggest that this not be attempted. But it's your pistol.
Well, it depends on the type of sights. For open sights(no scope) if the bullet hits to le left of where you are aiming, move the rear sight to the right. If the bullet hits high, move the rear sight down. If you have a scope, when the bullet hits left, use a coin to twist the knob on the side of the scope clockwise and if its hitting high, twist the knob counter-clockwise.
I had to go look at my Quest 1000x and could not find any hole in the sight, but my Quest is about 4 years old and Crosman may have added it to yours. Usually a sight with a small hole is called a peep sight. I have a notch sight on my rifle. The only other hole on top of the rifle is towards the back of the barrel and that is a Scope stop. Some scopes have a pin on the bottom pf the scope mount to place in the hole, this keeps the scope from moving when the rifle fires.