The simple answer is:it depends. If you are using rod-pocket curtains, the rod could be placed as low as 85-86 inches off the floor. However, if you are using curtain rings, than the rod might need to be placed much higher. The best solution is to take the curtains and any hardware you are going to be using and hold it up to the wall at the desired distance off of the floor.
You should only leave 1 inch between the wall and the start of the floor register. It is also recommended that the floor register be placed underneath a window.
The bed skirt should be approximately one inch from the floor. If it is more than one inch from the floor, then any contents hidden under the bed will become visible. Leaving approximately one inch from the floor allows the space under the bed to benefit from air circulation.
The most affordable caravan curtains can be made from clean and used bed sheets. The rings can be made by bending a coat hanger back and forth until it snaps into four inch segments. these are easily bendable and should require one hangar per curtain.
You will need at least 6.06 square meters of material.
No, most curtains do not come with rods.
12x12 square hole in basement floor what is it for
74 square inches
If you're installing hardwood floor boards over a strong 3/4 inch plywood sub-floor, then yes, you can install the hardwood floor parallel to the joists. If your sub-floor is weak, then you should fix the subfloor.
four inch
The standard size of shower curtains is 180 cm x 180 cm comes with rings. The shower curtains are designed to fit a standards 60 inch long bathtub. Shower stall size are not as standardized as bathtubs, and therefore curtains to fit stalls are available in several different sizes.
It depends on a number of factors. The main thing which determines the length your shaft should is the distance between your wrist and the floor, and your middle finger to the floor. The best thing to do is to go get custom fit and see, being 6' 2'' you may need and extra half inch or inch.
left side of the chest. A company logo is usually placed on the left chest, or on the area 1/2 inch to 1 inch above the pocket.