Easy get a Phillips head screw driver stick it in half way and push down on it hard and eventually the bearing will pop out!
Yes, most bearings are the industrial standard of 8mm unless you have special longboard trucks, most notably Bear 1052's or 1045's or Bear Smokeys, these trucks run 10mm but are not very common. If you can take wheels off with the same wrench on both trucks, then they have the same size bearings.
No
I recently did this for my 2004. I found it was cheaper to replace the entire wheel hub then to buy the bearings. The bonus is the new wheel hub comes with the bearings already to go.
The Lancer does have wheel bearings on the front. If you would like to find them yourself, go to www.mitsubishiparts.com. The Lancer does have wheel bearings on the front. If you would like to find them yourself, go to www.mitsubishiparts.com.
go to dealer
SkateB=board bearings are made with stainless steel or metal, but the persission of the wheels go the opisite, if the wheel is 5, then it will go slower, if it is 3, it will go faster.
The wheel will begin to wobble and can eventually fall off if you don't get it fixed.
Call your local auto parts store. Front wheel bearings can go from $50 to $200 (plus labor) depending on manufacture.
Tires, wheel bearings chains, clutches and bolts.
I can see no earthly reason why.
yes, you need to find a bolt that is quite long and stick it through the holes on the scooter so that about 5 inches of it is sticking out on the side you want the peg to be on, slide skateboard bearings on the bolt and screw a bolt on the end, there you go, a scooter peg.
Bearings where, motor, wheel ? In either case, they can go bad that quickly and without notice. Sometimes things just happen. Engine bearings go almost immediately with no oil. Blocked oil passage or bad oil pump will do it. A wheel bearing can have been dry for a while without making noise and then seize up. You could also be being scammed. Engine bearings will knock if only a little bad and a wheel bearing will squeal or lock the wheel.