On the passenger firewall in the engine compartment beside the heater/ac blower. It is a 1"x1" cube about 2" tall.
How do you change the heater coil in a 1994 chevy caprice?
in the fuse box
hi, i need to know how to replace the heater core with a/c on a 1994 gmc jimmy. a diagram would be helpful
AnswerDepends whats broken ie. blows cold, no blower at all ???????no blower at all
Resistor on the heater blower motor has failed
cost to replace heater core 1994 corsica
On my 1994 RH Drive, it's located on the passenger side, in the duct on a shield.
There is none - usually it is the module in the top of the heater / blower box (resistor module) that is the problem.
I would like to change the blower motor in my 1994 Ford Tempo by myself. Do you have any instructions for me to follow?
under glove box passenger side
Only for the high speed blower function. The lower speeds go thru the blower motor speed resister.
On my 1994 it is circuit #5 , 25amp
The only relay in the heater system would be for the high speed function of the blower motor. That rely would be located under the hood, on the firewall, close to the blower motor resistor.
How do you change a heater core in 1994 chevy astro van?
On the bottom of the heater/AC housing under the dash.
The heater core in a 1994 Mazda MPV is under the dash on the passenger side. The dash has to be taken apart to change out the heater core.
I own a 1994 acura integra and the heater/air conditioning blower is not working, I can not defrost my windows and the heat does not blow. What is wrong and how can the problem be fixed.
The heater resistor on a 94 Astro is located on the top of the heater box under the hood, it has a four or five wire plug on it and two 6mm screws hold it in a hole in the heater blower box.
you have to remove the dash
disconnect the electrical connector from the blower motor and remove the 3 screws from the blower motor housing.pull the blower motor and fan straight down. to remove fan from blower motor,squeeze spring clip togetherand slip fan off the shaft.some models have no clip or screw holding fanto shaft, in this case use 2 screwdrivers to pry it off.install fan onto blower motor housing and install blower motor into the heater housing.
If you have only high speed on the blower motor or you are missing one or more low speeds, chances are the blower motor speed resistor is burned out.