This requires a good repair manual (Motors, Chilton, Bentley to name some) a lot of tools, and someone whom is experienced and mechanically inclined.
If your asking if it can be done without removing the transmission? NO.
Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.
On top of the transmission, near the clutch slave cylinder.
How do you replace a slave cylinder on a 1995 dodge neon clutch
You have to remove the transmission from the engine to access the clutch, remove the old, replace with new, and reset (turn) the flywheel. Something most mech. will replace for $300-$500.
How do you replace the safety neutral switch on a 1995 Jeep Cherokee 5-speed transmission and Where is the safety neutral switch located?
I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.
You have to split the transmission, maybe even drop it out. There might be some helpful info on www.autozone.com
Just take the transmission off and the clutch will be exposed. Its that simple. Of course you need to remove the clutch cover, if any fingers are bent or broken, then replace the cover. While your at it replace the release bearing and pilot bearing.
pull out the transmission
The 1995 Accord ghas a hydraulically operated clutch, notg a cable.
I need an answer to this too.
if you change filter @4.5 to 5 qts
no not at all not enough room.if it's standered and you need to replace the clutch you have just enough room to remove and install the clutch remember cut the clutch tool in half
The speed sensor is in the engine compartment on a 1995 Nissan Sentra GXE automatic transmission. It is on the back of the transmission.
need to remove transmission, sounds like a bad clutch if your goin to replace that, replace the flywheel also, but stock oem flywheels are discontinued, you could get a used one and get it resurfaced but it's best to go with a new one in mycase, i got an act2100 clutch and act prolite flywheel
The slave cylinder for your hydraulic clutch is inside the transmission bellhousing
The 1995 Nissan vehicle speed sensor is located on the side of the transmission. The vehicle speed sensor will be on the left-hand side of the transmission.
How TO REPLACE THE TRANSMSSION: CALL A MECHANIC
Yes, you most certainly can. Just don't try it with a transmission from a 1.3L - you'll be missing the shifter brace!
As long as it is the same engine, you also have to swap some other parts out such as the clutch petal.
Could be a number of things, check your your transmission fluid, if the level is fine, it may be your transmission or clutch. Most likely your clutch, which is cheaper than a transmission.
6-speed or 4-speed auto
I'm assuming you mean the pressure plate on the clutch. It is a time consuming job. The transmission has to come out. Then the clutch comes out. It is about a $600 job to get this done and also put in a new clutch disc. Unless you know your way around transmissions and drive shafts I would suggest having it done.
take it to your nearest Honda dealer