both cannot exists if either one is missing.
Current and Voltage are directly proportional. V=voltage, I=current, R=resistance V=I*R
in ac circuits power,P=VICOS@ @ is the angle between voltage and current. in dc P=VI V is the voltage I is the current. Power (in Watts) is current (A) x voltage (V)
Current, voltage and resistance are related by the Ohm's law formula which states that current is directly proportional to the applied voltage and inversely proportional to the resistance at a constant temperature. Stated mathematically: I = E/R where I = current in amperes, abbreviated to A E = voltage in volts, abbreviated to V R = resistance in ohms, usually signified by the Greek omega Ω
Power (watts) is voltage times current.
Voltage and current are two different things. Voltage is the electric potential difference between two points. Expressed in volts, it is also joules per coulomb. Current is the charge flow past a point. Expressed in amperes, it is also coulombs per second. You can relate voltage and current using Ohm's Law, which states that voltage is equal to current times resistance. Resistance is, therefore, equal to voltage divided by current. Using base units, resistance is equal to joules per coulomb divided by coulombs per second, which simplifies to joule-seconds per coulomb squared. That is a difficult unit to write, so we just use ohms as the unit.
Resistance = Current x Voltage This is commonly written R = IV note: this means (ohm)=(coulomb/second)(volt)
1). Voltage = (resistance) x (current)2). Current = (voltage) / (resistance)3). Resistance = (voltage) / (current)I think #2 is Ohm's original statement, but any one of these can be massaged algebraicallyin order to derive the other two.
Current (amperes) is the rate of flow of electric charge, in coulombs per second. Voltage, on the other hand, is the electric potential of that charge, in joules per coulomb.Current and voltage are related to resistance by Ohm's Law, which states that voltage is equal to current times resistance.There is a tendency to misuse the term "current", and to apply it, for instance as "an electric current of 120 volts". This usage is incorrect. Current is current, and voltage is voltage, as noted above.
in ac circuits power,P=VICOS@ @ is the angle between voltage and current. in dc P=VI V is the voltage I is the current. Power (in Watts) is current (A) x voltage (V)
the answer is current, voltage, and resistance
Voltage, current, and resistance can be related by this formula. V = iR, where I is the current. Assuming that the voltage stays constant, current will decrease. Hope this helps!
Ohm's law: voltage is current times resistance. Restating this; current is voltage divided by resistance, so increasing resistance would decrease current.