It will be reverse biased and will not light.
If you connected neutral and earth (ground) to each lead in an LED and it glowed then this would be evidence of a ground fault.
The power consumption of the led is very low and the life of LED bulb is high. Hence LED's are used as cost saving and energy saving measure and not hte conventional incadscant indicator bulbs. ...
A circuit board consists of numerous electronic components, depending on the application, these components can be in the thousands or in the ten's, therefore circuit boards vary in numerous sizes, all connected using very fine electrical connection strands.
A LED has a forward voltage drop dependent on it's composition. It is fairly constant within a small range of current flow. If the voltage is too high and the current is not limited, the LED will burn out. The brightness can be varied by varying the available current, but the voltage across the LED remains virtually the same.
The first evidence that led people to think that the continents were once connected because of earthquakes
Archduke Franz was connected to the great war in that his assassination led to the war.
It will be reverse biased and will not light.
A: That resistor is there to limit the current to the LED it can be any value if the voltage is decreased or increased or no resistor if the voltage across the led is equal to the forward voltage drop.
in a flashing led circuit connected in series
If the patch card is connected with the mgmt port then this kind of amber LED glows...
As the capacitor charges the led will dim until it's minimum operational voltage is reached and it goes out.
It was connected to a river that led to Asia.
Yes. A Christmas light string composed of LED lamps can be connected on an incandescent light string. The outlet at the end of a Christmas light string has (or is supposed to have) the source voltage.
If you connected neutral and earth (ground) to each lead in an LED and it glowed then this would be evidence of a ground fault.
The power consumption of the led is very low and the life of LED bulb is high. Hence LED's are used as cost saving and energy saving measure and not hte conventional incadscant indicator bulbs. ...
The answer to your question is Vitus Bering.