Attached to the underside of the motor, accessed by removing the oil pan.
It is accessed from the top front of the engine. The oil filter is a canister type cartridge, not a spin-on.
The owner's manual says that it can be accessed from under the car by removing the protective panneling. The same panneling needs to be removed for accessing the oil plug and changing the oil.
The engine oil sending unit on your Dodge 2.7 liter engine is located in the bottom of the engine. The oil sending unit can be accessed by removing the oil pan.
Normally on all motors, the oil pump is located above the oil pan inside the motor. This being the case, the motor will have to be extracted from the engine compartment where it can be accessed.
The rear main is accessed by removing the trans and flywheel. There is no need to remove the oil pan.
Just above the oil filter. The oil filter is accessed through a small skid plate panel (2ea. flat head or phillips head screws)
Inside the engine block, accessed via the sump pan. Follow the oil strainer up the pick up tube.
It is towards the rear of the oil pan. It takes a 13 mm wrench and is is accessed behind the left front wheel, passenger side.
There are several in that transmission and they can be accessed by removing the transmission oil pan.
It can be accessed by removing the transmission oil pan.
the oil filter is on the driver side front next to or almost completely under the harmonic balancer, best accessed from under the front