it test flashing .
The square and the rhombus are both equilateral. All their sides are the same length. In the square, the angles are all right angles. If you make a square and have each vertex on a "hinge" so that they can move, you can "reshape" the square and make different diamond (or lozenge) shapes. As you pull and push the shape to change it, the sides always remain the same length, of course. The angles all change as you move it though. That's a rhombus.
Two thousand years ago, triangular sails appeared. With proper orientation, these sails could convert wind power from any direction into forward thrust. The sail might be pushed or pulled by the wind force, and the pull was stronger than the push. Although there was no physical understanding of the pulling force, it allowed the boat to sail into the wind.
Yeah they have 4 equal sides Only some parallelograms have 4 equal sides. Such a parallelogram is called a rhombus. In general, a parallelogram has two different pairs of opposed equal sides. Like a rectangle given a sideways push at opposite corners.
A right angle push-up tests for upper body strength and endurance. Below are instructions for how to preform a right angle push-up. 1. Lie face down (on your belly) on a mat/floor in push-up position with hands under your shoulders, fingers straight, and legs straight, parallel, and slightly apart, with the toes supporting the feet. 2. Straighten your arms and keep the back and knees straight 3. Lower your your body until there is a 90-degree angle at the elbows and your upper arms are parallel to the floor. They only part of your body which should be changing is your arms. The rest of your body should remain stiff and your knees should not be bending.
1. Turn off your calculator 2. Flip it over 3. Get a pen or sharp pencil 4. Push "reset" 5. Flip over 6. Done
Ridge push is a gravitation force that causes a plate to move away from the crest of an ocean ridge, and into a subduction zone. The Slab pull force is a tectonic plate force due to subduction. The difference is the force of motion.
because other factors as shown in that could play a role in plate movement are ridge-push and slab-pull.
what is diffrent pull and push
what is diffrent pull and push
This will be in detail for your information. 3 driving forces of plate motion...one plate moves underneath the other or a continental collision (if the 2... cause the gravitational sliding of lithosphere plates away from them...
Ocean plates to be subducted into the mantle
Three processes that contribute to the motion of tectonic plates are convection currents, ridge push, and slab pull. Convection currents is when the mantle rises, cools, sinks and heats, then rises and repeats the cycle. Ridge push is a gravitational force that causes a plate to move. Slab pull is the movement of tectonic plate lithosphere due to convection currents in the asthenosphere.
constant tectonic plate motion.
Force ;)
gravity
gravity
slab-pull and ridge-push