Ford Expedition Eddie Bauer

How is the throttle position sensor on a 1998 Ford Expedition Eddie Bauer replaced?

181920

Top Answer
User Avatar
Wiki User
Answered
2009-10-13 14:09:04
2009-10-13 14:09:04
Answer

The TPS is back near the firewall. It's held in with 4 bolts and connected to the throttle cable with another bolt. If your car is stalling because the TPS is sticking, a shot of WD40 will save you the cost of the part.


The TPS is nowhere near the firewall. It is mounted on the side of the throttle body. This is where the air cleaner duct routes into on the top of the engine. You will want to look on the driver side of the throttle body. There will be three wires running to the TPS sensor. Unhook the sensor. Remove the two screws that mount it to the throttle body. Install the new sensor. These are non adjustable sensors on the newer Fords. I've never seen WD40 save a TPS sensor.
001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The Throttle Position Sensor is conneceted to the end of the Throttle Shaft inside the Throttle Body. P.S. The Throttle Position Sensor is part of the Throttle Body and must be replaced as a unit. Hope this helps ya.

It has to be replaced. no adjustments.

The Throttle position sensor is monted on the side of the throttle body .

The throttle position sensor is actually apart of the throttle plate actuator assembly and must be replaced as a unit.

The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.

The throttle position sensor is in the throttle body.

The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.

A throttle position sensor is a sensor used to monitor the position of the throttle in an engine. The sensor is usually located on the throttle-body spindle so that it can directly monitor the position of the throttle valve butterfly.

The throttle position sensor is located on the throttle body at the end of the throttle shaft.

The throttle position sensor is located on the throttle plate.

The throttle position sensor is on the throttle body, opposite of where the cables attach.

The throttle position sensor is on the throttle body on the opposite side of the cables.

The throttle position sensor is on the throttle body.

The throttle position sensor is on the throttle body.

Generally speaking the throttle position sensor is on the throttle body.

No map sensor is manifold absolute pressure sensor and tps throttle position sensor

The throttle position sensor is located on the throttle plate, straight across from the throttle linkage.

The throttle position sensor is built into the electronic throttle assembly( throttle body) and is not available seperatly.

The throttle position sensor is on the throttle body at the end of the throttle shaft.

the tps or throttle position sensor is located directly to the throttle plate opposite of throttle cable's on the throttle body.

The throttle position sensor is the three wire sensor on the throttle body opposite of where the cables attach.

The Toyota Tacoma throttle position sensor is adjustable. There is an adjustment screw on the back of the throttle position sensor.

The throttle position sensor can be tested by moving the throttle as observing the engine's response. If it is smooth and consistent, the sensor is functioning properly.

No, the throttle position sensor detects how far open the intake is. The crank position sensor watches the rotation of the crankshaft.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.