After cleaning the sweat joint so it looks professional and inspecting the flow of solder at the joints you can turn the water on immediatly proving there are no more pipes to sweat. After cleaning the sweat joint so it looks professional and inspecting the flow of solder at the joints you can turn the water on immediatly proving there are no more pipes to sweat.
All flux has acid so yes u can as long as u wipe it clean after u solder it will cause Ur joint to turn green
Read the directions on the glue container!!!
counter-clockwise
You have to use the door opener and open the basement door then you turn off the water pipe.
A long handle with a chain attached is used on larger pipe. The chain is rapped around the pipe and attached to the handel. You can turn the pipe with this leverage.
A long handle with a chain attached is used on larger pipe. The chain is rapped around the pipe and attached to the handel. You can turn the pipe with this leverage.
Snow, watr, or ice getting into your exaust pipe then it melts...
turn off main tap at building entry point
The hot water pipe is not clamped properly. When the water flows through the pipe when you open the faucet, the turbulence makes the pipe move and bang against what ever it is not clamped to properly.
Before you begin any type of plumbing project, make sure the water in the home is turned off. There are so many times that people disconnect a water pipe in the home without having the water valve turned off. This makes a huge mess in the home from the water spraying out of the pipe. Allow all of the water to drain out of the pipe you are fixing after you turn the water off before starting on the project.
Without having a stop in the run you'll have to turn off the system, unless...If it is the hot water side you can turn it off at the water heater.
It makes noise because it's sucking the water back in to stop letting the water escape.