After cleaning the sweat joint so it looks professional and inspecting the flow of solder at the joints you can turn the water on immediatly proving there are no more pipes to sweat. After cleaning the sweat joint so it looks professional and inspecting the flow of solder at the joints you can turn the water on immediatly proving there are no more pipes to sweat.
All flux has acid so yes u can as long as u wipe it clean after u solder it will cause Ur joint to turn green
To repair a copper water line, you can start by turning off the water supply, cutting out the damaged section of the pipe using a pipe cutter, cleaning the ends of the pipe, and then soldering a new piece of copper pipe in place using a propane torch and solder. Finally, turn the water supply back on and check for any leaks.
To fix a hole in a copper pipe, you can use a pipe repair clamp or a soldering method. For a temporary fix, you can use epoxy putty or a rubber patch. It is important to turn off the water supply before attempting any repair.
Read the directions on the glue container!!!
To effectively repair a hole in a copper pipe, you can use a pipe repair clamp or a soldering technique. First, turn off the water supply to the pipe. Clean the area around the hole and apply a pipe repair clamp over the hole, tightening it securely. Alternatively, you can cut out the damaged section of the pipe and solder a new piece in its place. Make sure to follow safety precautions and consult a professional if needed.
To fix a burst pipe, first turn off the water supply to prevent further damage. Then, cut out the damaged section of the pipe and replace it with a new section using pipe fittings and a pipe cutter. Finally, turn the water supply back on and check for leaks.
counter-clockwise
You have to use the door opener and open the basement door then you turn off the water pipe.
A long handle with a chain attached is used on larger pipe. The chain is rapped around the pipe and attached to the handel. You can turn the pipe with this leverage.
To fix a pipe under the sink, first turn off the water supply. Use a wrench to loosen the fittings and remove the damaged pipe. Replace it with a new pipe and tighten the fittings securely. Turn the water supply back on and check for any leaks.
A long handle with a chain attached is used on larger pipe. The chain is rapped around the pipe and attached to the handel. You can turn the pipe with this leverage.
To fix a busted water pipe outside, you will need to first turn off the water supply to prevent further leakage. Then, locate the damaged section of the pipe and cut out the broken part. Next, replace the damaged section with a new piece of pipe and secure it in place using pipe fittings and a pipe wrench. Finally, turn the water supply back on and check for any leaks to ensure the repair was successful.