Want this question answered?
An automatic gearbox is maintained to keep it serviceable for a long time by changing the fluid and filters at regular intervals. The entire system should also be flushed periodically to remove contaminants.
There is no river called Laguna de Bay. Instead, it is the is the largest lake in the Philippines.
3miles
About a hour and a half
36 mm socket and a long ratchet or bar.
The gearbox will have to removed to replace the clutch. Disconnect battery earth lead (battery located under the front passenger seat) Remove the engine cover Disconnect the air flow sensor multi plug Disconnect the reverse light switch Disconnect the earth lead to the gear box Remove the crank position sensor from the top of the gearbox (this is to protect the sensor from damage) Remove the top bell housing bolts and starter motor bolts Slacken the gearbox top mounting centre bolt Removed the front wheels Remove the engine under shield Remove the engine to sub-frame mounting centre bolt Disconnect the exhaust support bracket from the sub-frame Unclip the power assistance steering hoses from their support bracket on the sub-frame Support the steering rack with some cable ties and then undo the 2 securing bolts to sub-frame Separate the lower suspension ball joints on both sides Support the sub-frame Remove the sub-frame securing bolts and lower to the floor Drain the gearbox oil (remembering to replace the drain plug afterwards) Remove the O/S drive shaft bearing support bolts and pop the drive shaft out of the gearbox Pop the N/S drive shaft out of the gearbox and cable tie clear to one side Remove gearbox closing plate Remove the hydraulic slave cylinder (no need to disconnect the hose) Pop the gear selection cables off the selector mechanism and then remove the unit Disconnect the speedo drive multi plug Support the engine with a long axle stand (take care not to damage the sump) support the gearbox with a transmission jack Undo the top gearbox mounting slackened earlier Lower the engine and gearbox until the top mounting bolt is clear Remove the remaining bell housing bolts Pull the gearbox and out Lower to the floor Refitting is reverse of removal, check the clutch environment for any signs of wear or oil contamination, rectifying before fitting the new clutch. Remember to top up the gearbox oil. Gearbox oil - EP75/80 X 1.8 ltr
7-8 years
Drop gearbox down from cross member,Use a power bar & several long extentions with a knuckle joint attatched!
You fill gearbox thru speedo hole! remove speedo cable housing ( 1 10 mm bolt) and just below gearbox housing. you have to remove the speedo drive with a small flat screwdriver . get a bit of hosepipe about a foot long and a funnel. put in 3 ltrs from empty. speedo drive is directly below air box.
yes as long as you have a licence
The heater matrix can be accessed from the front passenger side. Remove the glove box and the flow end return pipes for the heater matrix can be seen. You will need a fairly long T20. Torx driver.
it takes about 16 to 20 hours