As long as the good dental professional says:{}
Use dental floss to put it back them in. Stretch the floss out and thread the spacer through it ,and slide spacer back in. DON'T PUSH THEM DOWN WITH A TOOTHPICK BECAUSE YOU CAN IRRITATE THE GUMS!
Yes, you can. TBI stands for Throttle Body Injection, and a spacer can be used provided you have the clearance for it.
A spacer is a tiny little blue thing, that they put in between your teeth, to give room for the braces. THey do hurt for the first couple of days. But you'll be fine.!
You probably could but don't. You can put it in wrong and cause serious damage to you teeth.
Thread two pieces of floss thru the spacer then use them to stretch spacer out....like make it long and thin....then see-saw it in between your teeth. If you cant get it back in you will need to go back to your orthodontist before your next appointment bcuz they need that space.
We put Billet pulleys and Throttle body spacer on mine & I noticed a HUGE difference in performance. Also, we are going to put headers on it. I noticed about a 35 - 40% difference with just the spacer and pulleys.
Where can you buy a spacer
The wheel will be stuck or will shake the engine. if you put the spacer that attaches to the CV joint on back wards it will be hard to turn. there is a wrong way and right way to put that spacer on. I put mine on backwards and the wheel did not even turn. try cleaning it out with mineral spirits then regressing it and put back together.
There is one way that one can appropriately use a spacer when administering asthma medications. A spacer is used by attaching the spacer to the inhaler.
Spacer Instead of a Lip RingIt is not recommended. You should wait for the piercing to heal then change it. If you are forced to wear a spacer wear it no more than 4 hours. Otherwise it might get infected. AnswerYour piercist cant put in a spacer because they cant sterilize plastic, and you shouldn't remove your piercing for atleast 3-4 weeks.
In fact the wax spacer is used fill the space between the bobbins too (they are not tied togheter like on a regular humbucker. So this wax spacer meants to put the whole pickup assembly in place before you put the cover on.
Put one bearing in and tighten a table vice on the bearing in the wheel and then put the spacer and other bearing in and do it a gain hope this helped