Erm.. a couple of hours.
Provided there were no electrolyte or musculoskeletal abnormalities prior to death, the carcass should be in full rigor within 12 hours.
Rigor Mortis, a stiffening of the muscles, usually starts to take place at around 3 hours after someone is dead with full rigor occurring at about 12 hours after death. After the 12 hour mark the rigor slowly ceases and at around 72 hours rigor disappears.
2 an 1/2 days
5 to 4 hours
No they dont
How long it takes rigor mortis to set in depends on the size of the dog. The stiffening of the muscles usually begins within three hours of death and will affect small dogs much more quickly than large dogs.
30 - 45 seconds
Mortise and tenon A square hole with a square peg. If you look at a wooden table or chair. The leg has the mortise and the side rails have the tenon. The mortise is a rectangular hole slightly smaller than the width and thickness of the rail. On the rail, it extends past the visible length probably about 1 inch. This varies depending on the construction. This extension is between 1/8 to 1/4 of an inch smaller on each side than the rail. It fits into the mortise. Makes for a very strong joint. Mortise and tenon joints are also used in post and beam homes and timber frame homes. As the most common timber framing joint, the mortise & tenon is versatile and functional. It is used to fasten connectors, posts, collar ties, struts, etc. The tenon can vary in size from 1-1/2" thick by 4" long to 3" thick by 10" long, depending on the load requirements of a particular joint. It is held tight by hardwood pegs.
Rigor mortis is the stiffening of the muscles of a dead body, and takes place in the early hours after death. It is usually complete 4-6 hours after death (depending on the circumstances) and can be used to determine a time of death relatively accurately
if it is cold and stiff it is dead it doesnt take long you'll smell it soon.
I believe this refers to the size or width of the tenon. Making it almost the the size of the board it is in gives more surface area for glue.
Short answer: No. Long answer: Maybe. You need to wait till all the tests are complete first.