0
You can change the filter in about twenty minutes to a half hour. Do this by removing the passenger side inner fender skirt and going in from there with a large filter wrench. Cut a gallon milk container in half and use it underneath as cacth can for the fuel that will be released from the filter. Remove the plug from the bottom first to drain and remove filter. Replace filter and sensor in bottom with the new orings provided with filter. Once installed pump the primer on top as found in owners manual. Be patient pumping, it can take a few minutes. Reinstall wheel well and your done. You will get messy, trust me.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Should you have to bleed fuel lines before you change your fuel filter?
no that is not necesary you only put a piece of rubber to prove it works before you put the filter. If this work then you put the filter
A 1996 Nissan Sentra has no fuel pressure does it have a fuel shut off and if so where is it located?
Check fuel pump fuse. If you have changed the fuel filter on a 2000, you might have forgotten to put the rubber grommet between new fuel filter and fuel pump (look at your old fuel filter). Check fuel pump fuse. If you have changed the fuel filter on a 2000, you might have forgotten to put the rubber grommet between new fuel filter and fuel pump (look at your old fuel filter). Check fuel pump fuse. If you have changed the fuel filter on a 2000, you might have forgotten to put the rubber grommet between new fuel filter and fuel pump (look at your old fuel filter).
Where is the fuel filter in a 2006 Chevy Tahoe?
The fuel filter is inside of the fuel tank. in 2004 chevy moved the filter from the frame rail and put it in the tank.
Where is the fuel filter on a 2007 Tahoe?
In 2004 Chevy moved the fuel filter from the FRAME RAIL and put it in the FUEL TANK. That's crazy isn't it. You will have to drop the fuel tank down to service the fuel filter.
Fuel filter location 2005 silverado 5.3 motor?
Before 2004 Chevy put the fuel filter on the drivers side frame rail. After that year it was put inside of the fuel tank.
How do you change fuel filter on a 1990 corvette?
The fuel filter on a 1990 Chevrolet Corvette is changed by unscrewing the fuel line from both sides of the filter and removing the retaining clips. The filter can then be removed and a new filter put in its place.
Where is fuel filter located on 2007 Chevy 1500?
In 2004 Chevy removed the fuel filter from inside of the frame rail and put it in the fuel tank.
How do you change the fuel filter on a 2001 Chevy Duramax 2500?
The fuel filter is located on the passenger side of the engine, there is a water sensor located on the filter, so first u must disconnect the connector to the water sensor. Next you will need a large filter wrench to wrap around the filter and unscrew it. Remove the water sensor from the old filter and put it on the new filter (it unscrews). Dont forget to put the new gaskets you get with the filter on the new filter. Next install the filter back on the motor, and reconnect the water sensor connector. Before you can start the engine you will find a button on top of the filter that you must slowly press and release about 30 times to build fuel pressure. Try starting the truck after that, if the truck still wont start keep going back and pressing and releasing that pressure button. Make sure there are no leaks and you are all set.
What can you do to make a duramax diesel smoke?
Smoke is just unburned fuel, too much smoke is not good for the engine. Anything that causes the engine to run rich, or have more fuel in the fuel to air ratio will make it smoke. You can either put in more fuel by using a better lift pump, or using better injectors, or you can starve the engine of air (not recommended) by unhooking the turbo or putting a paper bag over the air filter. Smoke is just wasted power, a truck that burns all this extra fuel runs much faster. Note that the fastest duramax in the world blows little to no smoke.
How do you get a duramax to blow smoke?
Smoke is just unburned fuel, too much smoke is not good for the engine. Anything that causes the engine to run rich, or have more fuel in the fuel to air ratio will make it smoke. You can either put in more fuel by using a better lift pump, or using better injectors, or you can starve the engine of air (not recommended) by unhooking the turbo or putting a paper bag over the air filter. Smoke is just wasted power, a truck that burns all this extra fuel runs much faster. Note that the fastest duramax in the world blows little to no smoke.
How do you change a 2003 Toyota Camry fuel filter?
The fuel filter on a 2003 Toyota Camry is changed by removing the fuel line from each side of the filter and detaching it from the vehicle's frame. A new filter is then put into place and the fuel lines attached.
Where is the location of the fuel filter on a 2006 Chevrolet silverado 1500?
2004 and down GM. put the fuel filter inside of the frame rail. 2004 up to date GM. put the fuel filter inside of the gas tank. You will have to lift the bed up and remove the filter from the top of the tank. Are just drop the fuel tank out of the truck and then service the filter.
