In terms of power comsumption, it's simple - 10. 40 watts times 10 give 400 watts. In terms of lighting ability, it's not nearly so simple. Ten dim bulbs don't provide as intense a light source as one bright one. They can be spread out to better light a large area and maybe not have as many shadows as would a single light source, but nowhere will it be very bright, even if the ten dim bulbs are all next to each other. So, the proper answer to your question is, "There is no real 'equivalence' between the two."
You do not. CO2 has nothing to do with the creation of a light bulb. A typical incandescent bulb has a vacuum inside. No light bulb uses CO2.
Certain light bulbs are gas filled. Consider Xenon and Neon bulbs. The ideal for a filament bulb is to use a vacuum bulb, however, inert gases can also be used. The point is to avoid the rapid oxidation that occurs at high temperatures in the presence of air.
because if we will fill any other gas in bulb when it will come in contact with heat produced by bulb it will burst
Different kinds of light bulbs used different gasses. The incandescent bulb uses no gas - it uses a vacuum. Other kinds of bulbs may use nitrogen, argon, neon, or krypton.
If you squeeze the bulb to expel most of the air, then release it with the tip under water, the pressure in the bulb drops and external air pressure on the surface of the liquid in its container forces the liquid into the dropper. When you squeeze the bulb again, you increase the pressure and force the liquid out.
Yes, Sodium bulbs have a glass center piece and a glass bulb surround.
You need the appropriate ballast for either of these bulbs to make them light.
no
If both bulbs fit into the same socket I would presume this to be fine.
No, you can not use a 150 watt high pressure sodium bulb with a 70 watt ballast.
They are most likely a type of metal halide bulb. <<>> The above answer bulb has a bright white light output. If the light output has an orange look about it then the bulb is a high pressure sodium lamp.
The 400W high pressure Sodium bulb contains a silver lining inside the frame to give better reflection of light. However, no silver is found inside the bulb.
In most cases a cfl bulb can be replaced with an incandescent bulb as long as the base matches. for an example: if a cfl bulb has a GU24 base an incandescent bulb will not work! Also, ensure the wattage of the bulb does not exceed manufacturers rating.
352 There are six different types of light bulbs invented as of December 27, 2012. They include the incandescent light bulb, the halogen light bulb, the fluorescent light bulb, the high-density discharge lamps, LEDs, and sodium lamps.
This is different depending on the type of bulb. Most bulbs copper or kovar (or other alloy with thermal expansion rate matching that of glass) wires are used for connections.tungsten wire is used in incandescent bulbs for the filamentmercury liquid (which evaporates to form mercury vapor) is used in fluorescent bulbs and tubes as well as mercury vapor streetlight bulbssodium vapor is used in both high pressure sodium and low pressure sodium streetlight bulbstungsten studs are used as discharge electrodes in HID car headlight bulbsetc.
my HP sodium light just quit working. How can I tell if the bulb is out or the fixture mounted on the pole is bad. Hate to pay $35 for a bulb if the fixture is the culprit.
The plural form of the word "bulb" is "bulbs."