If you can tell me the resistance across the bulb, I can tell you the total wattage. Watt = amps x volts. I (amps) = E (volts 2.5)/ R (resistance in ohms). Calculate for amps draw on one lamp and then times 300 will give you total amperage. Take this value times total voltage and it will give you total wattage.
Yes. A Christmas light string composed of LED lamps can be connected on an incandescent light string. The outlet at the end of a Christmas light string has (or is supposed to have) the source voltage.
The load on a string of Christmas lights is typically located in the bulb itself. Each bulb is designed to produce light and consumes power when electricity passes through it. The collective load of all the bulbs on the string determines the amount of power required to illuminate the lights.
The average strand of Christmas lights pulls about 1 amp, which is roughly the same as a 100 watt light bulb running on 120 volts. It's hard to say how much running it will cost you for electricity, but one thing is sure: no one wants to leave their light on all day, same goes with the Christmas lights.
Yes, but the lamp output wattage will be a quarter of what it is at 240 volts.power = voltage squared / resistance
The string which is in the lowest position. The thin E string.
Yes. A Christmas light string composed of LED lamps can be connected on an incandescent light string. The outlet at the end of a Christmas light string has (or is supposed to have) the source voltage.
A connection string in computing is a string that specifies how to connect to a data source and information about the data source. It is commonly used in database files.
because it was used to hang on the Christmas tree as an ornament
The strcat() function has the following protocol:char* strcat (char* destination, char* source);The function appends the source string to the destination string and returns the destination string.The destination string must be a null-terminated character array of sufficient length to accommodate strlen (source) plus strlen (destination) characters, plus a null-terminator. The existing null-terminator and subsequent characters of destination are overwritten by characters from the source string, up to and including the source string's null-terminator.strcat (string, '!') will not work because '!' is a character literal (ASCII code 33 decimal), not a null-terminated character array. Use "!" instead of '!'.Example:char string[80]; // character arraystrcpy (string, "Hello world");strcat (string, "!");puts (string);
Tinsel? (:
At a hardware store.
You use some string
A pre-lit Christmas tree might not have all of the lights working because of a broken wire. There is also the chance that on the pre-lit tree if one bulb is burned out the entire string will not work. Check the bulbs in other working sockets by exchanging bulbs to find the one not working.
33 ohms
you put it on a string and hang it on the tree
2 amps. If it is D.C.
Plug the "string of lights" into the power point. If a particular light does not come on, then it is "bad".