Current (Amps) = Power (Watt)/Voltage (V) Therefore a 4500W heating element will draw 18.75A = 4500W/240V
Current (Amps) = Power (Watt)/Voltage (V) Therefore a 4500W heating element will draw 18.75A = 4500W/240V
5500/240=23 amps
23
Heating element is the main part of the ironbox which gets heated as current passes through it. We have to use the material for heating element with features such as: 1) high melting point 2) high specific resistance 3) not easily oxidised. (most important point) Hence the alloy NICHROME ( nickel and chromium) is used for heating element because it is not oxidised even at high temperatures.
how do you replace a kerosene heater wick for a kerosun omni230 heater?
1 Remove the air handler electrical disconnect. Pull out the electrical disconnect on the air handler. If you have an old air handler without an electrical disconnect, turn off the circuit breaker to the air handler.2 Remove the panel off the air handler. Use the screwdriver to remove all the screws holding the panel in place.3 Locate the electric heater in the air handler cabinet. Remove the ribbon cables on the electric heater. Remove all the screws holding the electric motor in place. After you have the screws and the cables off, you can safely pull out the electric heater. If you do not know what the electric heater looks like, look at the replacement heater for guidance.4 Place the new electric heater where the old one was. Secure the heater in place by installing the screws. Connect the ribbon cable to the electric heater to finish the wiring.5 Replace the air handler cover and secure it in place with the screwdriver. Turn on the power by inserting the electrical disconnect back in place or turn on the circuit breaker . Turn on the electrical heater and wait at least 10 minutes for it to start.For all your heating, cooling, and refrigeration needs in the St. Louis, Mo.metro area. Contact Ricotta Heating and Air 24/7. (636) 274-5900
KEROWORLD
a heater a thermal jacket water and food
Yes the wire size is larger for that size breaker but will not effect the 30 amp breaker protection of that circuit.
where is the heater blower resistor in a 2003 Honda element
The best element to use is a 3 phase electric heater that has a guard over the element protecting you from brushing against the hot part and stopping the element from starting a fire if the heater is pushed element down onto the floor
A convection heater works on the principle of air convection currents circulating through its body and across its heating element. Heating element heats up the air, causing it to increase in volume and become buoyant. A convection heater can have an electrical heater element, a hot water coil, or a steam coil.
Wouldn't recommend.
Not really.
Piston heater element open.
No way to fix that - your tank is scrap.
No. A water heater requires a 240 volt connection and cannot be re-wired to run on 120 volts. There isn't enough amperage in 120 volts to power the heating rods that are inside.
ring a plumber up
no as it will burn out the element
Yes you can.