Want this question answered?
RCC that is reinforced cement concrete which is composed of cement(mainly),sand(fine aggregate),metal(coarse aggregate)and water.Which is further more supported by iron which makes it RCC from ordinary cement concrete.
Fine aggregates are the aggregates whose size is less than 4.75 mm.Example: Sand is used as fine aggregate in the preparation of concrete and cement mortar.
The binder in concrete is usually cement. Cement causes the aggregate and sand to bind together mechanically and harden to make a solid surface.
Choose the grade of concrete & assume minimum water/cement ratio.Conduct some initial tests on the materials like cement, sand & metal(coarse aggregate).Tests like UNIT WEGHT, SPECIFIC GRAVITY,SIEVE ANALYSIS,SLUMP CONE TEST & COMPACTION FACTOR TEST. According to the obtained results do the mix design from IS CODE of IS800-10262 check for water cement ratio & calculate the quantity of cement, sand & coarse aggregate.
For M7.5 concrete, the common mix ratio is 1:4:8. This means:1 part cement 4 parts fine aggregates (sand)8 parts coarse aggregates. These ratio is by volume.
You will need about 7 25kg bags of cement.
Aggregate, Ordinary Portland Cement, sand, water
Concrete is what you make a sidewalk from. To make concrete, you mix Portland cement, sand, gravel (aggregate) and water. The cement holds the aggregate together.
10
Cement comes in bags that weigh 94 lbs. The volume of the bag is approximately 1 cubic foot. If you want to mix concrete which is a mixture of a coarse aggregate (gravel) and a fine aggregate (sand) and something to bond the two aggregates together (cement) then firstly you need to know the strength concrete that you require. For 1 cubic yard of 3000psi (pounds per square inch) strength you will need about 6 bags cement 12 cubic feet of sand and 24 cubic feet of gravel. Rule of thumb is the ratio should be 1:2:4 (cement:sand:gravel)
Actually, nothing is heated to create cement. Cement is a mechanically bonded combination of cement, sand, water, and gravel (aggregate).
100
From the largest manufacturer of backaged Portland Cement, bags come in 92.5 lb bags. To be clear, cement is mixed with sand and often aggregate (pea-gravel up to much larger rocks or other things such as broken out concrete chunks) to make concrete. Portland Cement by itself has no structural integrity when mixed with water. It must be mixed with sand at a minimum to make a hard, useful product (concrete). Concrete comes in bags weighing 50, 60, and 80 pounds here in the US.From the largest manufacturer of backaged Portland Cement, bags come in 92.5 lb bags. To be clear, cement is mixed with sand and often aggregate (pea-gravel up to much larger rocks or other things such as broken out concrete chunks) to make concrete. Portland Cement by itself has no structural integrity when mixed with water. It must be mixed with sand at a minimum to make a hard, useful product (concrete). Concrete comes in bags weighing 50, 60, and 80 pounds here in the US.
Yes. The cement used to make concrete usually has sand, aggregate and Portland cement in it. That would make it heterogeneous.
If a 20kg bag of cement=0.1m3 with 100 lots o 0.01 to 1m3 then you will need 12.5 bags per m3. So you need approx 11.5m3 of sand and 144 bags of cement (144 x 0.01 = 1.44m3) to give you a total of 12.94m3
For steel it can be taken as 2.5 % to 3%
equal parts to mix