It depends on weather its 4x4 or 2 wheel drive there are 8 0n 4x4 and 6 on 2 wheel drive
No. You can remove the engine and leave the transmission in the vehicle.
The automatic transmission fluid temperature sensor on a 1997 Chevy Blazer S10 is located on top of the transfer case. It is in the engine compartment.
3.73 if you have a 350good engine and automatic transmission
Assuming you have an automatic transmission the dipstick is located under the hood on the passenger side in back of the engine, close to the firewall.
There are 6 bolts that hold the trans. to the engine block.
Unbolt the the power wires after disconnecting the battery. Then pull out the 2 or three bolts holding it in. then pull out the starter. Reverse for installation.
That would be the 4L60E transmission.
Yes it will fit right in there and hook right up.
Possibly, but you haven't said which engine or trans.
Yes, but you have to remove the automatic transmission housing, and you have to replace the Torque Converter with a standard transmission clutch that matches the type of transmission with which you are mating the engine.
The transmission dipstick on a 1998 Blazer should be located at the rear of the engine. It should not be near the oil dipstick.
Yes the 1994 trans will physically bolt up to the jimmy engine. Unfortunately, the electronic transmission controls for the two vehicles are very different and are not compatible.