There are 2 bolts that hold the starter in place and 2 nuts that hold the wiring to the solenoid.
The starter on a 98 Oldsmobile Cutlass is located on the bottom, left side of the engine. It is held in place by a support bracket and bolts.
Remove the negative (black) cable from the battery. dissconnect any power wires running to the starter. remove two bolts located on the starter. Have someone help so they can hold the starter while you loosen bolts. When putting starter back in reverse procedure.
you probably have half American standard and half metric.
if there are no bolts in the door jamb then they are welded in and need to be ground down and new ones welded on
Back seat has to come out and the rear package tray too and then you can get to the bolts that hold the speakers in.
the hot wire goes to the starter and the ground wire bolts to the engine block.
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
First you remove the lower back seat, and the bolts that secure the upper will be exposed. Remove them and lift out upper back seat.
It requires removing the exhaust manifold in the front, and draining the A/C system. The starter is between the engine and the radiator. The line from the A/C compressor goes right by the starter. Really bad, the starter on an 82 Delta 88 came off with 3 bolts.
Follow the upper radiator hose from the radiator down to where it hooks up to the outlet. Outlet is held in place with 2 bolts. Remove the bolts and there is the thermostat. Drain coolant out first before removing thermostat.
I am trying to take the motor out of a 95' Olds cutlass supreme. The trans. is giving me problems. How many bolts hold it in.
it is located on the driver side underneath the engine. its circular in look with two lines one leading to the carburetor. two bolts leading into the engine. also there is a rod inside the mechanical fuel pump.