100 percent means full voltage or 0 dB.
When 75 percent of the voltage is lost you still have 25 percent of the voltage.
25 percent means damped to (-)12 dB.
It depends on the repeater. Those that receive a signal, buffer it in real time and pass it on as a digital signal will reduce the effects of attenuation. Those that receive a signal and regenerate it with a new clock signal will generally eliminate the effects of attenuation completely.The type of repeater used depends on where and how it is used as well as the signal that is being transmitted.
150 feet
It generally reads RMS value of the voltage being measured
It is usually required in electrical examinations to make calculations. Simple answer to a complicated calculation. Remember, take peak to peak voltage and multiply by .707, the result being average voltage. This is the voltage that electrical test meters read.
Voltage dividers are used in a linear circuit to separate the input voltage into a small portion known as the output voltage. It is commonly used to get a low voltage signal equal to the voltage being measured.
db=20log(V1/V2) or 10log(P1/P2) Example: db=20log (100/50) db=20log(2) db=20*.3010 db=6.02
Attenuation occurs in all copper cable regardless of whether it is twisted or not. This is because the copper atoms actually 'resist" the electrical voltage being applied (a physics principle).
RMS Output divided by input, usually expressed in deciBells. Depends on whether it is power or voltage being attenuated. Voltage, it's 20log(Vout/Vin) Power, it's 10log(Pout/Pin) The difference is because power is proportional to voltage squared.
Damping is the attenuation of vibrations or oscillations.
There's something missing from this question - voltage. Horsepower translates to Watts, with 1 hp being 735 W. But to get Wattage you need to calculate Amperes x Voltage. W/O voltage there's no way to tell how many amps you need to get 2 hp.
Because its attenuation is proportional to thickness being penetrated
fading also 'attenuation'
Noise (as related to a radio signal I suppose) is an unwanted signal being processed by a receiver. Attenuation is a loss of the intended signal before it gets to the receiver (usually due to such things as distance, line of sight obstructions, etc.
It depends on the repeater. Those that receive a signal, buffer it in real time and pass it on as a digital signal will reduce the effects of attenuation. Those that receive a signal and regenerate it with a new clock signal will generally eliminate the effects of attenuation completely.The type of repeater used depends on where and how it is used as well as the signal that is being transmitted.
150 feet
It generally reads RMS value of the voltage being measured
I believe it translates to 'to you too', with 'you' being plural.