book pays 9.6
How many hours does it take to take out and replace a transmission on a commercial tractor as a Mack? And what would be the average price?
labor hours to replace evaporators dodge grand caravan se 2009
anywhere from 3-5hrs. You have drop the transmission.
You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.You can not unclog it. You will have to replace it and that will take a mechanic about 2.5 hours.
about 6 hours
It depends on the vehicle. Some can be as easy as two hours, others could be over ten hours.
i got quoted 12 hours
no. you can pull the transmission out without removing the motor. ive done this twice in less than 3 hours
about $360 at Firestone Car Care
approx. 4 - 6 hrs peace
Mitchell OnDemand estimates 14 hours.
The transmission should be priced from $2000 - $2500 for the transmission. Labor to install transmission should be some where around 6 hours this price may vary depending on where you go for any estimate, that's why you ask how many hours they are charging you for.
the 1997 grand am has a timing CHAIN. it takes approx. 4-6 hours to replace. that is if you have done timing chains before. otherwise...it might take longer
10.6 for an automatic, add another 1.5 hours for a manual (clutch adjustments, etc...) Don't forget that there are always extra part costs.
I have a 2003 grand prix GT and the unlock code is 1040. use the hours and minutes and then press AM/FM. wait and it should work.
Grand Prarie, ND is an estimated 17 hours and 24 minutes. Grand Prarie, TX is an estimated 35 hours of driving time.
Typically, an experienced technician will take 2 to 3 hours to replace the ball joints. Alignment will take an hour and transmission flush will take less than an hour.
The duration of Grand Champion is 1.55 hours.
The duration of The Grand Olympics is 2.37 hours.
The duration of Our Grand Despair is 1.7 hours.
The duration of Shanghai Grand is 1.6 hours.
The duration of The Grand Maneuver is 1.77 hours.
It is located on the drivers side of the crankshaft pulley. The shop time to replace it is 1.4 hours and the part is about $80. It would be around $225 to have the dealer replace it.
i would say no more than 2 hours of labor after you purchase the parts. labor in my shop is $92/hr