answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-01-09 21:14:53

2 hours to 7 hours, depends on the engine size.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


You need to replace the water pump. This happened to my car.


Where can I get a diagram of a 1996 Dodge Intrepid cooling system?



2.7l is about $1000 to $1500 3.5 about $450 - $550 with a 2.7 the water pump is in the motor



This is a very big, labor intensive job. You will need to buy a service manual.


Your thermostat is possibly not opening up. Replace and flush and then recheck. Good luck.


If you have a 3.5 liter motor, take it to an independent shop, I would not recommend it for d-i-y ers.


expect about 2 hours labor and a recommdation from him to replace both serp belts and the timing belt too the serp belts need to removed to access the pump and the water pump is driven by the timing belt and if its gotten wet by the coolant it wont last long and may leave you stranded then its about 2 hours labor to replace the timing belt


2.7L near 8 hours3.5L near 4 hours2.7L near 8 hours3.5L near 4 hours


You have to take out the electric fans. then take off the belts and then you will have to pull the hurmonic balancer off take the timing cover off then take off the timing belt. the water pump is located in between the cams it is bolted on with 3 boltsand looks like a pully. this is for a 1996 dodge intrepid with the 3.5 v-6 you



Chrysler V6, six to eight hours. Mercedes/Dodge Sprinter, two to three hours.




it is located inside the engine, on the front, behind the timing cover.


How do I change the oil pan gasket on a 1999 Dodge Intrepid with 3.5 engine, what is the proper torque for the bolts.



sounds like bad head gasket(s)


It is inside the front of the engine, driven by the timing chain.


The flat rate labor time is over 6 hours. It takes me around 5.


From what I understand, it's not easy. It requires pulling the engine on the 2.7 liter model. Georgia "Book" labor is 7.8 hours for exchanging a water pump on this car for this reason.


inside the front of the engine, driven by the timing belt



On the 3.5 intrepid engine, the water pump is run by the timing "belt"- no timing chain on this motor. Not sure about the 3.3 motor. On the 3.3L the water pump is driven by the serpentine belt.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.