it is 3, one by the fire wall is hard to change you need to pick up the engine and trans. to change it.
On a 1987 Nissan Stanza, the engine mounts are typically located at the front and rear of the engine. The front mount is situated between the engine and the front crossmember, while the rear mount is located at the back of the engine, connecting it to the transmission or the firewall. Additionally, there may be a side mount on the passenger side of the engine to provide further support. These mounts help stabilize the engine and reduce vibration.
The temperature sensor on a 1987 Nissan Stanza is located on the rear of the radiator. It is about one-third of the way down from the top.
You can get a 1987 Nissan Stanza Wagon body kit at auto part stores. You can also check with a certified dealer.
It is at the top of the valve cover. Hope that heps!
Drain the water from your 1987 Nissan Stanza. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
If it is a four cylinder it will be: 1 3 4 2
It is located inside the fuel tank.
timing is 15 degrees before on both std and auto.
it might be under the passenger's seat covered by some carpet.
Its in front off the engine on the right side and it has a red cap on it.
restart the computer and by doing that disconnect the battery for 5 min
The 3.0 liter V6 in a 1987 Nissan Pickup is an interference engine