0
How many oxygen sensors on a Subaru Forester 1999 are they all the same type?
Wiki User
∙ 11y ago
Two. Same type meaning are they both heated oxygen sensors with platinum or some other rare metal on the tip? Yes. Same type meaning same part number? No.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the knock sensor on a Subaru Forester 1999?
Where is the knock sensor located on a 1999 Subaru Forester?
Where is the oxygen sensor located on your 1999 Subaru legacy outback sport utility sedan?
I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters. I just purchased new catalytic converters for my 1999 Subaru Legacy Outback. There are three ports for oxygen sensors. They appear to be on the top of the converters.
Where is the ECU and ECM modules located in a 1999 Subaru forester?
The ECU in a MY 1999 Subaru Forester is located at the upper left site of the engine under the air intake.
Subaru Forester 1999 oil capacity?
4..5 QUARTS
Locations of 1999 Subaru Forester air filters?
The 1999 Subaru Forester air filter is located in the engine compartment inside of the air box. There is also a cabin filter located behind the glove box.
How do you replace rear struts for a 1999 Subaru Forester?
hou to replace rear struts
Where is the thermostat for a 1999 Subaru Forester?
It resides at the engine side of the lower radiator hose.
Control fan 1999 Subaru Forester?
YES, without a doubt... Unless it is NO, certainly not.
Does a 1999 Subaru Forester have a manual transmission gasket?
Most if not all plugs have gaskets.
What ATF for 1999 Subaru Forester?
Atf4 is backwards compatible with atf3 that came with ur vehicle.
Where is the PCV valve on 1999 subaru legacy outback?
where is the pvc valve on a 1998 suaru forester?
How do you reset the 1999 forester ecm?
Resetting the ECM on a 1999 Subaru Forester requires the car to be off. Disconnect the negative battery terminal for t seconds and reconnect it. The computer will now be reset.
