The 8086 family of microprocessors, including the 8086, 80C86,
and 80C86AL, are presented in 40-pin DIP packages.
The 8086 microprocessor has 40 pins.
40 PINS
WHAT IS THE PINS CONFIGURATION OF 8086?
it have 40 pins 1st one is ground and last one is Vcc. Itplh = 450
The 8086 comes in a 40 pin package with 2 ground pins and one power pin; the remaining 37 signal pins every single one is important.
Pins 1 and 20 in the 8086 microprocessor are (both) power and signal ground (GND).
Two ground pins are used in the 8086 microprocessor to increase the bus pull-down current capacity.
The address lines A0..A15 are multiplexed with the data lines D0..D15 on the pins AD0..AD15
There are 256 ports available in the 8085 microprocessor. The IN and OUT instructions have an 8-bit port number, and that is where the 256 comes from.In order to use ports, the hardware addressing system must decode IO/M-. Some implementations don't do this, so they map IO addresses to memory addresses. In that case, you could say there are 65536 possible IO addresses, but that is not the same as ports, because ports are specific to the IN and OUT instructions.The other "problem" with IN and OUT is that you cannot specify the address in a register, while you can do so with indirect memory addressing.
One may buy military pins from most veteran websites. There are many different types. There are pins available commemorating service in different wars, different companies or divisions, and different specialties.
8086 have 5 interrupt lines.
There are 16 data lines in 8086.