0
What else can I help you with?
How many pins does a PATA cable have that supports ATA-5 and UDMA66?
A PATA (Parallel ATA) cable that supports ATA-5 and UDMA66 typically has 40 pins. This 40-pin connector is used to connect devices like hard drives and CD-ROM drives to the motherboard. Additionally, there is a 80-wire version of the cable that improves data transfer rates while maintaining the same 40-pin connector.
What are the two different types of PATA data cable?
40 and 80
A parallel ATA connector can accommodate one data cable for tow drives?
A parallel ATA connector can use one data cable for two drives.
Does pata connect to molex?
PATA (Parallel ATA) and Molex connectors serve different purposes in a computer's architecture. PATA is used for connecting hard drives and optical drives, while Molex connectors are typically used to supply power to these drives. PATA drives can be powered using a Molex connector, but they also require a separate data cable for the PATA interface. Therefore, while they are connected in terms of functionality, they do not directly connect to each other.
What is a Coaxial Media?
Media means type of data transfer, cable and connector but cable and connector can also be called medium. and coaxial is a type of cable which is mainly used for ethernet
What is coaxial media?
Media means type of data transfer, cable and connector but cable and connector can also be called medium. and coaxial is a type of cable which is mainly used for ethernet
What are two types of PATA data cables?
Under parallel ata, two types of ribbon cable are used. The 80-conductor ide cable has 40 pins and 80 wires Forty wires are used for communication and data, and an additional 40 ground wires reduce crosstalk on the cable. An older 40-conducror cable has 40 wires and 40 pins. the two types of cables are PATA and IDE cables which come in a 80-conductor IDE cable and a 40-conductor cable
Explain how the two available drives on FDD data cable are distinguished?
Floppy data cable is 34 pin flat cable having two connectors for floppy drive. The floppy drive connected at the end connector is A: and the another connector disk is B:..
Which type of drive connector was replaced by SATA?
SATA (Serial Advanced Technology Attachment) replaced the older PATA (Parallel Advanced Technology Attachment) connectors. PATA, also known as IDE (Integrated Drive Electronics), utilized parallel data transfer, which limited performance and scalability. SATA introduced a faster, more efficient serial communication method, allowing for improved data transfer rates and easier cable management.
How can you tell the difference between the hard drive data cable from the floppy drive data cable?
1. A floppy cable will almost always contain a small "twist" in it, in which a port of the wires are turned in reverse.2. A floppy cable has 34 pins. A PATA hard drive cable has 40 pins.
A parallel ATA connector can accommodate one data cable for two drives?
true
What is a possible effect of improperly applying a connector to a network cable?
Data transmitted through that cable may experience signal loss.
