60-66PSI I think.
It should be on the bottom or bottom edge of the radiator.
The 2000 Olds Bravada uses Dextron iv automatic transmission fluid. The fluid is specific and other types should not be substituted.
try replacingthe rad cap it worked on mine
the blazer or jimmy hub and bearing assembly should work on your 96 bravada they are basically similar vehicles
its attached to the distributor, right at the base, should have two electrical plugs going into it, one from the coil
Holding the button down for several seconds should reset the display info to zero
The information should be on the drivers door post and in the owners manual. In most cases the tire pressure will be around 32 pounds.
there should be some kind of a panel or small flap in the rear that you would fill it up look around the cargo area
the driveshafts come out of any vehicle, because they're spline fitment, they should be held in by the suspension/steering components though
No, a wheel bearing should not set off a low tire pressure light in a 1999 Oldsmobile Alero.
The Pressure Has To Be Arround 30 to 40 psi
you shouldn't have to, there should be a line running from the main reservoir through lord knows where to reach it. so if it's plugged or cracked.... well.