A 2005 has 3 coil boots on the front head, and 3 wires w/boots for the rear plugs.
six spark plugs three coil packs with rubber boots on the end of them.make sure u install correctly
A 2004 Hyundai Santa Fe 2.4 has two spark plug wires, for cylinders #1 and #3. Cylinders #2 and #4 use what's known as "spark plug connectors" or "coil to plug boots".
coil on plug system one coil for each spark plug mounted at top of spark plug
Many possiblities. It depends on if you have a coil or an HEI ignition. If you have a coil, check your distributor to make sure your coil wire is attached properly. If your coil is attached, unplug it from your distributor and hold it close to the connection while someone cranks your engine. If you do not see a spark, your coil is bad. If you do see a spark, your rotor might be bad, or your points.
To change the spark coil pack on a 1998 Pontiac Sunfire with a 2.4 engine, first disconnect the battery. Then remove the coil pack and spark plug. The spark plug should also be replaced with the new coil pack for best performance. Insert the new spark plug, then the new coil pack being careful not to bump any of the many other electronic parts. Then reconnect the battery.
8 coils16 spark plugs8 coils16 spark plugs
16, two per coil
4...under the coil cover
each spark plug has its own ignition coil on top of the plug, like many current cars.
REMOVALEach individual spark plug is located under each ignition coil. Each individual ignition coil must be removed to gain access to each spark plug. Refer to Ignition Coil Removal/Installation.Prior to removing ignition coil, spray compressed air around coil base at cylinder head.Prior to removing spark plug, spray compressed air into cylinder head opening. This will help prevent foreign material from entering combustion chamber.Remove spark plug from cylinder head using a quality socket with a rubber or foam insert. Also check condition of ignition coil O-ring and replace as necessaryInspect spark plug condition. Refer to Spark Plug Conditions.INSTALLATION Special care should be taken when installing spark plugs into the cylinder head spark plug wells. Be sure the plugs do not drop into the plug wells as electrodes can be damaged.Always tighten spark plugs to the specified torque. Over tightening can cause distortion resulting in a change in the spark plug gap or a cracked porcelain insulator.Start the spark plug into the cylinder head by hand to avoid cross threading.Tighten spark plugs. Refer to torque specifications.Before installing coil(s), check condition of coil O-ring and replace as necessary. To aid in coil Installation , apply silicone to coil O ringInstall ignition coil(s) Refer to Ignition Coil Removal/Installation
Two, located under the spark plug cover.
8 on each spark plug ================================================== That should be 8 , 1 coil on each of the 8 spark plugs