1995-1999 Dodge & Plymouth Neons
Ford Expedition Eddie Bauer
Ford Expedition XLT
Grand Am SE

How many starter bolts does the 1998 Plymouth neon 4l sohc engine have?

91011

Top Answer
User Avatar
Wiki User
2006-11-20 21:12:36
2006-11-20 21:12:36

2

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.

User Avatar

on the front of the engine at the bottom near the oil filter.

User Avatar

No. The engine mount may be in the way depending on the engine.

User Avatar

Gas engine has a bolt at the top and a nut on a stud on the bottom. The diesel starter is held by three bolts.Gas engine has a bolt at the top and a nut on a stud on the bottom. The diesel starter is held by three bolts.

User Avatar

Look on the lower end of the engine Should have 2 mounting bolts

User Avatar

are there 2 bolt ot 3 bolt on a starter on 1998 neon

User Avatar

A 1998 Plymouth Breeze engine is fuel injected so there is no carburetor

User Avatar

Should be at the lower rear end of the engine Remove the - battery cableRaise and support vehicleRemove wires from starter solenoid at top of starterRemove starter mounting boltsRemove starter

User Avatar

The starter for a 1998 Cavalier is mounted on the side of the engine. It is at the rear, near the bottom.

User Avatar

* Disconnect the negative battery cable * Remove the air intake duct and the air cleaner housing assembly from the engine compartment * Disconnect the battery cable and the solenoid terminal connection from the starter solenoid * Remove the starter motor mounting bolts and detach the starter from the engine

User Avatar

Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.

User Avatar

The 1998 most likely has a Northstar engine. On this engine the starter is under the intake, and the intake has to come off for replacement.

User Avatar

how do you change a timing belt on a 1998 Plymouth breeze 2.0 liter engine

User Avatar

Remove the positive cable from your 1998 Saturn battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

User Avatar

I have a 1998 Chrysler Voyager and to change the water pump I found that after loosening the bolts there was simply not enough space between the engine and the engine side wall to get it out. The solution is simply to put a jack under the engine to support it, then remove the engine mounting bolts and use the jack to lift the engine enough to get the water pump out from the top of the engine. Then put the new one in, tighten the bolts and put on the belt again. Then lower the engine and put on the engine mounting bolts.

User Avatar

The starter is on the radiator side of the engine, behind the engine mount bracket.

User Avatar

The starter bolts on a 1998 Dodge Dakota require a 5/8 inch socket or wrench.

User Avatar

You can replace the timing belt on a 1998 Plymouth Breeze 2.0 engine using a Harmonic Balancer Puller 5.

User Avatar

Disconnect battery. Locate starter, it's under car where engine and transmission meet. If you must raise vehicle, ensure it is properly supported!!! Remove bolts securing wires to starter, then remove bolts secureing starter. Install new part in reverse order of removal. Tip: Use a 6 point socket to loosen bolts securing starter

User Avatar

the starter is located on the right side of the engine.

User Avatar

Remove the positive cable from your 1998 Monte Carlo battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.

User Avatar

When a started malefactions on a 1998 VW Passat the solenoid will make a clicking noise but the engine will not turn-over. To replace the unit remove the two bolts mounting the part onto the transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.